Sepura SER8040 User Manual

Installation and Operation Guide
Installation and Operation Guide
DMR Repeater
SBR8040/SCR8040/SER8040
1
Installation and Operation Guide
General
Disclaimer notice
Sepura’s policy is to continually improve its products. The features and facilities described in this document were correct at publication, but are subject to change without notice.
Contact Us
Sepura plc. Radio House, St Andrew’s Road, Cambridge CB4 1GR United Kingdom Tel: +44 (0)1223 876000 Fax: +44 (0)1223 879000
© Sepura plc. 2014
SPR-DOC-03800/1
Original Instructions: ENGLISH
All rights reserved. This document is intended for the use of Sepura plc’s customers and/or other parties only for the purposes of the agreement or arrangement under which this document is submitted, and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Sepura plc.
Contents
Safety ........................................................................................ 2
Regulatory ................................................................................ 4
Disposing of this product ............................................. 4
Technical specification ........................................................... 5
Controls, connectors and components ................................. 7
Status indicators ...................................................................... 7
Unpacking................................................................................. 8
Accessory information ............................................................ 8
Installation ................................................................................ 9
Guidelines and recommendations ................................ 9
Wall-mount bracket installation.................................... 9
Attaching the desk mount feet ................................... 10
Connections ........................................................................... 11
AC power supply ....................................................... 11
DC power supply ...................................................... 11
Antenna ................................................................... 11
Basic operation ...................................................................... 12
Power on/off ............................................................ 12
Voice and data transfer ............................................. 12
Alarm mode ............................................................. 12
Configuring the Repeater .......................................... 12
Caring for your product......................................................... 13
Duplexer specifications ........................................................ 13
1
DMR Repeater SBR8000, SCR8000, SER8000
Safety
Read these safety instructions carefully.
Attention!
This product is restricted for occupational use and is not intended or authorised for use by the general population.
It is the responsibility of the person operating the product to ensure that it is operated safely at all times, and that local laws and regulations governing the usage of Radio Frequency (RF) products are observed.
Users must be trained to operate this product safely. Their personal safety could be affected if they do not understand how to operate this product correctly.
CAUTION! Product weighs 12.5 Kg, take care when lifting.
Exposure to RF energy
Sepura designs and manufactures products to meet strict guidelines and international standards relating to Radio Frequency energy and the potential health risks associated with using such products.
This product contains radio transmitters and receivers that receive and transmit Radio Frequency (RF) signals when switched on. The antenna radiates RF energy only when transmitting and not in standby mode.
Users should be informed of the potential health risks associated with long term exposure to RF energy by their employer.
RF energy interference with electronic equipment
Some personal medical devices, such as hearing aids and pacemakers, can be affected by RF energy. Always consult your
service provider or the manufacturer of the medical device before using RF wireless devices.
Accessories
Sepura products have been tested to meet strict guidelines for personal safety and operational conditions. Only accessories approved by Sepura are recommended for use with this product.
Always read the instructions supplied with the accessory for additional safety instructions.
Unauthorised modifications to the product could cause the product to become non-operational and void any product warranty.
The use of non-approved accessories may invalidate any product warranty and may compromise the product safety ratings.
Servicing
Do not attempt to dismantle this product. Servicing and repairs to this product must be performed by
trained service technicians at Sepura approved service centres.
CAUTION! This product has double pole/neutral fusing.
FCC NOTICE
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an controlled
2
environment. The antenna should be installed and operated with minimum distance 1.0m from human body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for
help.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Installation and Operation Guide
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications were met.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each
3
DMR Repeater SBR8000, SCR8000, SER8000
antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de modèle s'il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
IC Radiation Exposure Statement: This equipment complies with IC RF radiation exposure limits set forth for an controlled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antenna should be installed and operated with minimum distance 1.0m from human body.
Regulatory
Sepura declares that this product is complaint with the essential requirements and other relevant provisions of the European R&TTE directive 1999/5/EC relating to radio and
telecommunications terminal equipment and the mutual recognition of their conformity. This product is also compliant with directive 2011/65/EU having been designed and manufactured to the RoHS requirements.
Disposing of this product
This symbol on the product or its packaging indicates that this product must not be disposed of as household or commercial waste. Some countries have set up collection and recycling systems for waste electrical and electronic products. By ensuring that this product and its
packaging is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health, and help conserve natural resources. Please dispose of your waste product according to your national and local regulations. Contact Sepura or your Service Provider for information about disposing of this product in your region of the world.
4
Loading...
+ 10 hidden pages