Sepura SEM8040H Installation guide

DMR Mobile

Vehicle Installation Guide

SEM8040H

This Installation Guide provides basic instructions for installing the DMR mobile
transceiver into a vehicle. This product can be installed into various makes and
models of vehicles and therefore this is not intended to be a definitive guide to
installing the product.

Always read the vehicle manufacturer’s handbook before starting to install the
product. Installation of this product may affect the vehicle electrical systems.
Contact the vehicle manufacturer if you are not certain if it is safe to install this
product.

The installation should comply with FCS1362 CODE OF PRACTICE for the

installation of mobile radio and related ancillary equipment in land based vehicles

(see http://www.fcs.org.uk).

SPR-DOC-03806/1

Original Instructions: ENGLISH
© Sepura plc. 2014

Sepura’s policy is to continually improve its products. The
features and facilities described in this document were correct
at publication, but are subject to change without notice.

Unpacking

DMR Mobile

(1) DMR Mobile
(2) Fist microphone
(3) Mounting bracket
(4) Microphone hanger
(5) Fuse (spare)
(6) DC power cable including fuse holder and fuse
(7) ST4.8x20 self-tapping screw (6 pieces)
(8) ST4x16 self-tapping screw (2 pieces)
(9) Knurled knob lock screw (2 pieces)
Unpack the contents of the box and ensure that all items are received in good

condition. If any of the goods are damages or not supplied, notify your Service
Provider within 10 days of receipt of equipment.

1

Vehicle Installation Guide

Connectors

(1) Antenna connector
(2) Power cable connector
(3) GPS antenna connector
(4) Interface connector

Safety

This product may affect public broadcast radio, security code alarm systems and
some engine management systems.

The installation of this transceiver must be performed by a qualified vehicle
installation technician.

This product must be installed in accordance with national and local radio
communications authorities and/or Health and Safety regulations.

Always switch off the transceiver in environments where RF wireless devices could
potentially cause an explosion. Potentially hazardous areas are not always signed.
Obey all signs and instructions relating to the usage of RF wireless devices.

Do not attempt to dismantle this product.
In order to reduce the risk of RF burns, the antenna must always remain connected

whilst the equipment is switched on. Under no circumstances should the antenna
be connected or disconnected whilst the equipment is switched on. Do not touch
the antenna when the transceiver is switched on.

Do not touch the heatsink fins when the transceiver is switched on. There is a
potential risk of a burn injury.

If a non-approved accessory is fitted, it may compromise the product safety ratings
and may void any product warranty.

It is recommended that the vehicle battery is disconnected before installing the
product. Always read the vehicle handbook to establish whether it is practical to

2