RC3
Quick Start Guide
Installation
There are three ways of installing the RC3.
Using the Adhesive Tape
Battery Release Hole
Center Button
Battery Slot
Getting Started
Note:
•
When closing the battery slot, insert both ends of
the rubber rst.
•
To remove the battery, insert a paper clip through
the Battery Release Hole.
1
Using the Clip
1 2
(-) Button(+) Button
Using the Hook and Loop Fasteners
1
Hook Fastener
2
Loop Fastener
16.Aug
32
0 ~ 30%
Button Operation
Battery Check
Factory Reset
Tap
Tapping
Tap
Double Tapping
1”
Press for 1 sec
Power On/Off
Power On
Tap
Center
Button
Deep Sleep
(+) Button+Center
Button
1”
Press
Status LED
...
-
-
...
-
...
Power On
70 ~ 100%
30 ~ 70%
Bluetooth Pairing
8”
(+)
Button
Headset
Note:
• You can control the headset using the RC3 only
after you pair them together.
• The RC3 supports Sena headsets with Bluetooth
4.1.
Press
Pairing
Remote Control Pairing
+ +
Center
Button
(-) Button(+) Button
1”
Press
Headset Control
To control your headset using the RC3, please refer to the
Quick Reference Guide for button operations on functions
such as phone, music, and intercom.
Sena Technologies, Inc.
www.sena.com
Customer Support
E-mail
: support@sena.com
: support.sena.com
4 5
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received. Including interference that may cause
undesired operation
Note : This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
ÿ Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisee aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement. ÿ
Caution: Any changes or modifications in construction of this device which are not expressly approved
by the party responsible for compliance could void the user's authority to operate the equipment.
Hereby, SENA TECHNOLOGIES.Inc Declares that this RC3 is in compliance with the essential
requirements and other relevant provisions of directive 1999/5/EC.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Loading...