SENA TECHNOLOGIES SP11 User Manual

User Guide

Sena Bluetooth® Pack for GoPro ®

CONTENTS

_Toc366852332

INTRODUCTION ............................................................... 3

PACKAGE CONTENTS .................................................... 4

GETTING STARTED ......................................................... 5

Attaching the GP10 to GoPro HD HERO .................. 5

Removing the GP10 from GoPro HD HERO ............ 6

Powering On/Off ....................................................... 7

Factory Reset .. ......................................................... 7

OPERATION ..................................................................... 8

Pairing with SENA headsets ..................................... 8

Recording during Intercom Conversation ................. 9

Recording in Mixing Mode ...................................... 10

Checking Battery Status ......................................... 11

INTRODUCTION

Thank you for choosing the Sena Bluetooth® Pack for
GoPro ®, you can pair Sena headsets and record intercom
conversation or external s ources in mixing mode. If you
are using other Bluetooth headsets it can be also paired
and possible to record your voice.

Please read this user guide carefully before using this
Bluetooth pack. Also visit www.SenaBluetooth.com for the
latest version of the user guide and for additiona l
information related to Sena Bluetooth products.

Sena Bluetooth® Pack for GoPro ® includes the following features:

 GoPro Hero3
 Up to 3 Sena headset paring available
 Other motorcycle Bluetooth headset paring available
 Other mono & stereo Bluetooth headset pairing available

TM

compatible

3

2

PACKAGE CONTENTS

(TBD)

* In this manual, the power button is referred as the

Power Switch.

* In this manual, the main button is referred as the

Pairing Button.

* In this manual, the mixing mode button is referred as

the Mic mix Switch.

4

GETTING STARTED

Attaching the Sena Bluetooth pack to GoPro

1. Slide hooked end of the Bluetooth pack into the

groove on the right side of the camera body.

2. Push the Bluetooth pack into the HERO Bus port

on the back of the camera.

3. Connect USB connector between GoPro and Sena

Bluetooth pack.

Removing the Bluetooth pack from GoPro HERO

1. Disconnect USB connector

2. Pull back on left side of theBluetooth pack marked

with thearrow to disconnect from the HERO bus
port.

3. Slide hooked end of theBluetooth pack out of

cameragroove.

Powering On/Off

1. Push the Power Switch down to power on. Then the

LED flashes blue.

2. Push the Power Switchupward to power off.The LED

flashes blue and you will hear the voice prompt

“Goodbye”.

Factory Reset

When the Bluetooth pack is not working properly
or is in faulty status for any reason, you can reset
the Bluetooth pack.

1. Press and hold the Pairing Button for 10 seconds

to enter the factory reset mode. Then the LED turns
on red.

2. Tap the Pairing Button to reset the Bluetooth pack.

5

6

OPERATION

Pairing with SENA headsets

1. Pressand hold the Pairing Buttonfor 5 seconds.

2. When hearing high-tone beeps, release thePairing

Button. Then the LED flashes red and blue
alternately.

3. Search for and select the Bluetooth pack on the

SENA headset to pair with it. For details on pairing,
refer to the User Guide of the SENA headset.

4. When the LEDflashes blue twice, the paring is

completed and the Bluetooth pack is ready to use.

7

8