Seip UK 60, UK 80, UK 100 Installation Instructions Manual

Installation Instructions

For Garage Door Opener

UK 60 / UK 80

UK 100

With automatic chain tensioner

Installation Instruction UK - Page 1

Please read these
installation instructions

carefully!

We disclaim all liability
under the terms of the
warranty for any
damage caused by
improper

installation!

Serial number:

GB

1. You have unpacked your UK garage door

opener and have it in front of you.

2. Take the part designated with a 2 in the drawing,
and place it in front. Slide the C-profile coupling
piece over part 2 all the way home.
Part 1 and part 2 are now connected
with one another.

3. When mounting part 3, make absolutely

sure not to twist the chain!

Chain

Leave the C-profile coupling piece so that
protrudes about 10mm (0,4 ") past part 2. Then

take part 3 and set it in the C-profile coupling

piece at an angle, inserting it from above as
shown. To tension the chain, press down on

part 3.

4. Push the C-profile coupling piece forward as far as it will go,
then screw in at least one fixing screw to secure it.

5. If you want to impart even greater stability to your C-profile rail, then
screw in all of the supplied fixing screws.

The chain has been pretensioned in the factory; do

not change the chain tension!

Preassembly

Installation Instruction UK - Page 2

1

2

3

12

3

1

2

3

2

3

1

Let the C-profile

coupling piece

p

rotrude(by10mm

)

To

tension

chain

2

3

10 mm

10 mm

Minimum headroom Installation on lintel Installation on ceiling

When mounting as shown in the
diagrams at right, make sure there
are at least 35 mm (1,37") of head­room between the ceiling and highest

point reached by the door while pivoting.

Installation without the minimum headroom of 35 mm
If there is not enough room to leave the minimum headroom of 35 mm, then the opener

must be mounted with a drawbar extension (available as an optional extra).

Extension piece

Procedure

Mounting

Installation Instruction UK - Page 3

35 mm
Minimum headroom

Lintel attachment angle
Mount the lintel attachement
angle above the middle of
your garage door, either on
the lintel or on the ceiling.
Make sure to leave the
required minimum headroom.

Emergency release
The Bowden pull-wire for the
emergency release must be
attached to the garage door.
Handle in such a way that it is
pulled downwards when the
handle is turned.

Attaching the drive unit
When attaching the drive unit
to the ceiling, we recommend
placing a ladder underneath
it.