sE Electronics T2 User manual

sE Electronics

T2 – Technical Information

This mic is the ultimate combination of high-detail solid state performance and
versatility. Based on the chassis and feature spec of the acclaimed 4400a, but with the
highly specialised capsule of the original Titan, it delivers full, and perfectly balanced, mid
and low frequencies, while its Titanium capsule produces un-hyped but ultra-detailed
High Frequency (HF) response.
It is thus ideally suited for percussive recordings, including of course drums and
percussion, but also things like picked guitar, the hammer action on piano, kick drum,
slap bass etc.
More, it is the ideal broadcast mic for spoken word; since the intelligibility of any speech
recording comes with good denition of HF (the percussive elements of speech such as
‘p’ and ‘t’ sounds), it is especially important for any mic used to deliver great HF response.
However, simply hyping the HF with an EQ can cause the sound to be sibilant and harsh
sounding, and invariably adds noise. The T2 however delivers a perfectly balanced HF
response due to the extremely fast HF transient response of its Titanium sputtered
capsule, thus giving exceptional intelligibility without the hype and noise.

The T2 - Perfect for percussion and percussive instruments, perfect for spoken word.

www.seelectronics.com

0

10

0

20

Hz

dB

T2

Technical Specications

Acoustical operating principle

Directional pattern:

Frequency range: 20 Hz ... 20 kHz

Sensitivity at 1 kHz into 1
kohm:

Rated impedance: 200 ohms Maximum SPL for THD 0.5%

Rated load impedance: 1 kohms

Equivalent noise level, CCIR2) : 25/26/25 dB1) Maximum output voltage: 1000mV

1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS

2) Measured as equivalent el. input signal

Pressure gradient
transducer

Omnidirectional,
Cardioid, Figure-8 plus

24/25/24 mV/Pa1) Maximum SPL for THD

Equivalent noise level, A­weighted2):

Signal-to-noise ratio, CCIR2)
(rel. 94 dB SPL):

Signal-to-noise ratio, A­weighted2) (rel. 94 dB SPL) :

0.5%3) :

with preattenuation3) :

Maximum SPL for THD 0.5%
with preattenuation3) :

16/16/16 dB-A1)

69/68/69 dB1) Supply voltage (P48, IEC

78/78/78 dB2) Current consumption (P48, IEC

122 dB (cardioid) Matching connectors: XLR3F

132dB Weight: 280g

132dB Dimensions:

Dynamic range of the micro­phone amplier (A-weighted):

61938) :

61938) :

Polar pattern and Frequency Chart

Cardioid

106 dB

48 V ± 4 V

5 mA

57mm L X 29mm W X
143mm H

sE Electronics

Polar pattern and Frequency Chart

Figure of 8

Polar pattern and Frequency Chart

www.seelectronics.com

Hypercardioid

Polar pattern and Frequency Chart

Omni