Page 1
REFLEXION FILTER® X ASSEMBLY + USE
Page 2
sE Electronics RF-X Assembly + Use
Thank you for purchasing an sE Electronics RF-X! We hope it helps make your
tracks sound great - no matter WHERE you’re recording.
STEP ONE
The rst step is to attach the hardware to
the stand, which is done by screwing the
bracket onto the top of a mic stand, where
the mic or shockmount normally attaches.
*There’s an adapter screwed
inside this connector for a
European mic thread size - if
you remove the adapter, the
connector will t US mic stands.
Use the lever on top of the L bracket
to tighten it, but not too tight, as you’ll
probably need to shift it slightly later.
STEP TWO
Next, attach the lter to the vertical portion
of the L bracket by inserting the two included
screws through the vertical cutout in the L
bracket, and into the two screw holes on the
back of the RFX.
RF-X ASSEMBLY MANUAL
Page 3
sE Electronics RF-X Assembly + Use
STEP THREE
Your microphone, in a shockmount or a clip,
will attach to the hardware with the included
standoff.
You can now play with the horizontal
positioning of the mic, and the height of
the RFX, to get the optimum position for
recording.
The ideal placement for your microphone is where the mic’s capsule is approximately
even with the front edge of the RFX, and centered vertically with the lter – but some
mics sound better when pushed a little closer, and some a little further away.
Once you’ve found a good position for the mic and lter, you can loosen the lever on top
of the mic stand mount to move the lter and mic assembly forward or back – this way,
you can position it so its center of gravity is balanced directly above the mic stand.
Thank you for being an sE customer - enjoy your new RF-X!
For more information, and to register for your extra year
of warranty, please visit seelectronics.com.
RF-X ASSEMBLY MANUAL
Loading...