sE Electronics Reflexion Filter Space User manual

REFLEXION FILTER® SPACE ASSEMBLY + USE

sE Electronics RF Space Assembly + Use

Thank you for purchasing an sE Electronics RF Space! We hope it helps

make your tracks sound great - no matter WHERE you’re recording.

STEP ONE

The fi rst step is to attach

a

c

b

the hardware to the stand,
which is done by loosening

the metal clamps (a), fi tting

the stand between them,
and tightening the key (b)

for a secure fi t.

If your stand’s diameter is
very large or very small, you
may have to adjust the large
threaded nut (c) opposite the

turning key to fi t.

STEP TWO

Next, make sure the L

d

bracket is attached to the
rest of the hardware using

the smaller metal key (d).

sE Electronics RF Space Assembly + Use

STEP THREE

Now, attach the fi lter to the L

f

g

bracket with the two included
round screws (f), which go through
the vertical cutout on the L bracket
and into the two holes in the back

of the Space fi lter (g).

STEP FOUR

h

Your microphone, in a
shockmount or a clip, will attach
to the hardware with the included

standoff (h).

*The included adapter
must be used for
5/8” (US standard)

threaded mounts.

sE Electronics RF Space Assembly + Use

The ideal placement for your microphone is where the mic’s capsule is

approximately even with the front edge of the fi lter, and centered vertically
with the fi lter – but some mics sound better when pushed a little closer, and
some a little further away.

Once you’ve found a good position for the mic and fi lter, you can loosen the
lever on top of the mic stand mount to move the fi lter and mic assembly
forward or back – this way, you can position it so its center of gravity is
balanced directly above the mic stand.

Thank you for being an sE customer - enjoy your new Refl exion Filter®!

For more information, and to register for your extra year

of warranty, please visit seelectronics.com.