Seco-Larm SLI 762FP-ISS Specsheet

Tel: [phone] (Domestic U.S. & Canada) Email: [e-mail] Website: www.seco-larm.com
16842 Millikan Avenue, Irvine CA 92606 Tel: [phone] (California and International) Fax: [phone]

pi-SLI 762FP-ISS.docx

Copyright © 2009 SECO-LARM U.S.A., Inc. All rights Reserved.
The SECO-LARM policy is one of continual development. For that reason SECO-LARM reserves the right to change prices and specifications without notice. SECO-LARM is not responsible for misprints.

Touchkey Immobilizer

Features:

 Fully automatic arming 30 seconds after ignition is turned off.
 Disarm by inserting Touchkey into Backlit Receptacle.
 Immobilization of up to two electrical circuits (e.g. starter,

ignition, fuel pump) once system is armed.

 Two built-in 30-Amp relays.
 Two Touchkeys supplied with each unit. Up to 4 Touchkeys

can be learned with a simple code learning procedure.

 Each Touchkey has millions of possible code combinations.
 Unique security code to override if Touchkey is lost or stolen.
 Stylish Backlit Receptacle for easy use and operation at night.
 LED located in Backlit Receptacle flashes to indicate

immobilizer is armed, disarmed, or triggered.

 Mini tamper-proof housing with all black wires helps prevent

the disabling of system by thieves.

 EEPROM stores codes for up to one year if power is lost.
 Multiple car operation: One Touchkey can control all vehicles.

Specifications:

SLI 762FP-ISS

The SLI 762FP-ISS Touchkey Immobilizer combines high security with the convenience of completely

passive arming. To arm, turn off the ignition. 30 seconds later, up to two of the car’s electrical circuits are

disabled. To disarm the system, insert the Touchkey momentarily into the Touchkey receptacle. You now
have 30 seconds to start your vehicle or the Immobilizer will rearm.

Operating voltage

10~15 VDC

Current draw (standby)

5mA@12VDC

Current draw (active)

230mA@12VDC

Number of relays

2

Relay rating

30A@12VDC

Operating temperature

-40°~185° F (-40°~80° C)

Passive Operation

To exit the car, turn the engine OFF. 30 seconds
later, the red LED starts flashing. The Immobilizer

is armed and up to two of the car’s electrical

circuits (starter, ignition, fuel pump) are disabled.

Status

LED indicator

Armed

Flashing

Disarmed

Off

Triggered

On

Built-in Multifunction LED:

Indicates armed, disarmed, and triggered modes.