Seco-Larm AS-6111Q User Manual

Installation Manual

AS-6111Q

Motion Entry Alert

Battery

Operated*

Up to

10ft

(3m)

Easy

to install

Installation and Important Notes:

1. This device is designed for motion alerts only.
It is not designed to be a security device, and should never be used
for security purposes.

2. Note that the sensor operates by detecting sudden changes in visible
light and is not suitable for areas of total darkness or facing a strong
light. It is suitable for indoor locations only—do not install where it could
be exposed to moisture, extreme temperatures, or direct sunlight.

3. Mounting – For use as a door annunciator, mount on the wall next to a door frame
with the sensor hole facing the door. However, it can be installed anywhere someone
is expected to pass. The normal installation height is about 20"~40" (50~100 cm) above the
oor and the detection range is 10ft (3m).

4. The sensor can be installed using adhesive tape (included) applied to a clean, dry, smooth surface.
For more permanent installation using the included screws, rst remove sensor from bracket by
carefully expanding the arms of the bracket until the sensor can be pulled free. Install the bracket
using the two screws.

5. Carefully remove the battery cover by pressing on the cover and sliding outward. Install the correct
batteries (3 AAA batteries, not included) using correct polarity as indicated and replace the cover.

6. Re-install the sensor to the bracket. Turn on the sensor adjust the direction.

7. When the batteries run low, the device will frequently activate. In this case, replace the batteries.
NOTE: Replace all three batteries with fresh ones at the same time when needed.

8. When not used for long periods of time, remove the batteries to protect the internal electronics.

Specications:

Power

Current

Low battery indicators
Input signal
Output signal
Sensor range
Material
Dimensions (with bracket)
Weight

*Requires 3 AAA batteries (not included)

SECO-LARM U.S.A., Inc.

SECO-LARM U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606

16842 Millikan Avenue, Irvine, CA 92606
Tel: [phone]

Tel: [phone]
Fax: [phone]

Fax: [phone]

Standby
Active

®

®

1.5VDC AAA batteries x3 not included

Device will repeatedly activate

10ft 3m at 20"~40" 0.5~1 m height

3 /8"x3 /8"x2" 85x85x50 mm

( )

Under 0.05mA 4.5VDC

Under 85mA 4.5VDC

CDS sensor

Doorbell sound

( ) ( )

ABS plastic, white

3 3

3-oz 84g

@

@

( )

( )

Parts List:

1x Sensor
1x Bracket
2x Mounting screws
1x Adhesive mounting tape

WARRANTY: This SECO-LARM product is
warranted against defects in material and
workmanship while used in normal service
for 1 (one) year from the date of sale to the
original customer.

PICRN1

www.seco-larm.com

[e-mail]

Copyright © 2015 SECO-LARM U.S.A., Inc.

MI_AS-6111Q _160128.cdr