
OWNER'S
MANUAL
MODEL NO.
274.43428590
SERIES
Record the Model No. and the
Serial No. of your television in
the space provided.
Model No.
Serial No.
Keep this information for
future use.
\
SEARS
25" TABLETOP
COLOR TELEVISION
WITH REMOTE CONTROL
SafetyInformation
Use
Warranty and Service
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.

Important Information
WARNING
To reduce the risk of fire or
shock hazard, do not expose
this TV to rain or moisture.
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
This symbol indicates
"dangerous voltage" inside
the product that presents a
risk of electric shock or
personal injury.
This symbol indicates
important instructions
accompanying the
product.
Cautions
CAUTION:
To prevent electric shock, match wide blade of plug to wide
slot, fully insert.
ATTENTION:
Pour 0viter les chocs 01ectriques, introduire la lame la plus
large de la fiche dans la borne correspondante de la prise et
pousser jusqfi au fond.
Operate TV only on 120 volts, 60 Hz AC power (normal house power).
FCC Regulations state that unauthorized changes or modifications to this
equipment may void the user's authority to operate it.
Note To Cable TV Installer
This reminder is provided to call your attention to Article 820-40 of the
National Electrical Code (Section 54 of the Canadian Electrical Code,
Part 1) which provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system
of the building as close to the point of cable entry as practical.

Table of Contents
Important Information Warning, Note to Cable Installer ........ i
Quick Guide to Your TV
Startup 2-3
Hook up your TV, Plug in the TV, Put Batteries in the Remote,
Turn on the TV, Place Channels in Memory, Set the Time
Basic Tour of the Remote 4
Power, Volume, Channel and Special Buttons
Menu Basics 5
Colors, Menu Buttons, Moving through the Menus
Using Your Remote
With Remote Buttons
Adjusting Your "IV
Overall Picture 7
Picture Settings 8
Color, Tint, Brightness, Sharpness, Autocolor, Picture Reset
Using Advanced Features Placing Channels in Memory/Autoprogram
Setting the Sleep Timer
Setting the Alarm Clock
Watching Closed Captioning
Setting Your TV for Antenna or Cable
9
10
11
12
13
References Front Panel Buttons
Displays on the Screen
Trouble Checks
Limited Warranty
14
15
16-17
Back Cover

Quick Guide to Your TV
Startup
The steps below will get your TV connected and ready for watching. For
more details, see the page numbers listed.
1. Hook up your TV
Match your type of antenna or cable
It is important to use only UHF&VHF
the adapters specified as ]]
they incorporate special _ OR
isolation circuitry to meet
safety regulations.
\ Use Onl
Adapter
\
Hook up your antenna or
cable to the TV before you
follow the steps below.
2. Plug in the TV
Plug the cord into the outlet,
matching the wide and the small
end of the plug with the outlet.
3. Put Batteries in the Remote
A. Pull off the cover of the battery
compartment.
B. Place two AAA batteries as
shown, matching the + and -
end of each battery in the
compartment.
C. Replace the cover.

Quick Guide to Your TV
Startup
4. Turn on the TV
Mun _Evc.
CE3_)
C.AN
CU_ _.U RESEt
Press POWER on the remote.
OR
Press POWER on the 'IV.
5. Place all available
channels in memory
(Autoprogram)
Details for adding and deleting
channels are on page 9.
Controls
Alarm Ad
13
a.
Press MENU until the Setup menu
is selected. This menu is white.
B. Press VOLUME + to place
channels in the TV's memory
(Autoprogram).
C. Wait until TV has cycled through
all the channels and returns to
original channel.
6. Set the Time 12:21 AM 13
ust Setup
A. Press MENU until the Alarm
menu is selected. This menu is
green.
B. The Clock is automatically
highlighted the first time you
set it. If it is not, press
CHANNEL down to highlight it.
C. Press VOLUME -- to set the
hour.
D. Press VOLUME + to set the
minutes.
F. Press CLEAR to remove the
menus from the screen, or the
menus will automatically
disappear from the screen, after
a brief period of time.

Quick Guide to Your TV
Basic Tour of the Remote
Basic information about your remote is shown below. This will give you a
general idea of how your remote works. For more details, see page 6.
Power Button
Volume and Channel Buttons
Details are on page 6.
POWER
MUTE PREV CH
O 0
VOL'_VOL
CHAN
l'ull15 the TV on and oft.
Operates the TV.
Scans up and down through
channels in the TV's memory.
Raises and lowers the sound.
Special Buttons
Details are on page 6.
POWER
MUTE PREV CH
(_1 E£)
CHAN
V
CLEAR MENU RESET Operates special features
of the TV.
4