Page 1
OPERATOR’S MANUAL
®
Ultra-Slim Travel Inverter 120
Converts 12V DC Power to 110V AC
Household Electrical Power + USB (5V)
Model No.
200.71520
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000860/0808
Page 2
TABLE OF CONTENTS
SECTION PAGE
1. IMPORTANT SAFETY INSTRUCTIONS 1
2. PRODUCT FEATURES 2
3. BEFORE USING 2
4. OPERATING INSTRUCTIONS 3
5. LED INDICATOR AND SHUTDOWN PROTECTION 3
6. POWER SOURCE 4
7. USAGE EXAMPLES 4
8. SPECIFICATIONS 4
9. REPLACEMENT PARTS 5
10. TROUBLESHOOTING 5
DIEHARD ONE-YEAR FULL WARRANTY
When operated and maintained according to all supplied instructions,
if this DieHard product fails due to a defect in material or workmanship
within one year from the date of purchase, return it to any Sears store
or other DieHard outlet in the United States for free replacement.
This warranty does not include fuses, which are expendable parts.This
warranty gives you specic legal rights, and you may also have other
rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
FOR CUSTOMER ASSISTANCE OR REPLACEMENT PARTS,
CALL TOLL-FREE BETWEEN 7 AM TO 4:30 PM CT
MONDAY THROUGH FRIDAY: 1-800-SEARS-64 (1-800-732-7764)
Page 3
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL.
IMPORTANT SAFETY INSTRUCTIONS1.
Before using your Travel Inverter 120, read and understand this Owner’s
Manual.
Keep the inverter well ventilated in order to properly disperse heat gener-1.1
ated while it is in use. Make sure that there are several inches of clearance around the top and sides and do not block the slots of the inverter.
Make sure the inverter is not close to any potential source of ammable 1.2
fumes, gases or clothing.
Keep the inverter dry.1.3
DO NOT allow the inverter to come into contact with rain or moisture.1.4
DO NOT operate the inverter if you, the inverter, the device being operat-1.5
ed or any other surfaces that may come in contact with any power source
are wet. Water and many other liquids can conduct electricity, which may
lead to serious injury.
Do not place the inverter on or near heating vents, radiators or other 1.6
sources of heat.
Do not place the inverter in direct sunlight. The ideal air temperature for 1.7
operation is between 50° and 80°F.
Do not use the inverter near an open engine compartment.1.8
Only connect the travel inverter to a 12-volt accessory outlet. 1.9
Make sure the AC plug connection is tight. 1.10
Do not modify the AC or USB receptacle in any way.1.11
Use only 15 amp fuses.1.12
Incorrect operation of your inverter may result in damage and personal 1.13
injury. WARNING: The inverter output is 110V AC and can shock or elec-
trocute the same as any ordinary household AC wall outlet.
WARNING: Pursuant to California Proposition 65, this product contains
chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
• 1 •
Page 4
TRAVEL INVERTER 120 PRODUCT FEATURES2.
2
3
4
5
1
2
3
4
5
6
7
1. Blue LED Indicator
2. 3-prong AC Outlet
3. USB Port
4. Power Cable Plug
5. Power Cable
6. 15A Fuse (inside of unit)
7. Protective Case
8. Velcro Strips (not shown)
BEFORE USING TRAVEL INVERTER 1203.
It is important to know the continuous wattage of the device you plan to
use with the inverter. The Travel Inverter 120 must be used with devices
drawing 120 watts or less. If the wattage is not marked on the device, an
estimate can be made by multiplying the AC input current (Amps) by the
AC voltage (110V).
Devices like TVs, fans or electric motors require additional power to start
(commonly known as the “starting or peak power”). The Travel Inverter
120 can supply a momentary surge in wattage; however, even devices
rated less than the maximum 120 watts can exceed the inverters surge
capability and cause an automatic overload shutdown.
Make sure the device you are using is compatible with a modied sine
wave inverter.
• 2 •
Page 5
OPERATING INSTRUCTIONS4.
Connect Inverter Power Cable: 4.1
Plug the included power cable into the inverter. Note, the plug will only t •
into the outlet one way.
Push the 12V end (cigarette plug) of the power cable rmly into the 12V •
accessory outlet. The LED indicator light should glow BLUE verifying the
inverter is receiving power. If the LED indicator is not on, check the connection and fuses.
Connecting and using the AC or USB device:4.2
Make sure that the device to be operated is turned OFF.•
Plug the device into the Travel Inverter AC outlet or USB port.•
Turn the device on. If the device doesn’t work and the LED blinks, refer to •
section 5.
Note: A “buzzing” sound emitted from a sound systems is the result of
ineffective lters in the sound system. This can be resolved by purchasing
a sound system with a higher quality power supply or higher quality lter.
Mounting the Travel Inverter 120 in your car: 4.3
Peel and stick the Velcro strips on back of holder•
Attach holder to desired location in vehicle•
Slide inverter into case•
LED INDICATOR AND SHUTDOWN PROTECTION5.
The LED glows BLUE automatically when plugged into a 12V DC source
and will shut off or blink under the following conditions:
When the power input from the vehicle’s battery drops to approximately 10 5.1
volts, low battery shutdown occurs and inverter shuts off.
When the power input of the vehicle’s battery exceeds 15 volts, high volt-5.2
age overload protection occurs.
The continuous load demand from the equipment or device being oper-5.3
ated exceeds 120 watts.
The case temperature becomes hot (exceeds 145°F).5.4
Reset: After shutdown occurs, determine and correct problem before 5.5
resetting.
• 3 •
Page 6
POWER SOURCE6.
Your average automobile or marine battery at full charge will provide an
ample power supply to the inverter for approximately 3 hours when the engine is off. The actual length of time the inverter will function depends on
the age and condition of the battery and the power demand being placed
by the device being operated with the inverter.
Turn OFF the device plugged into the inverter before starting the engine.
To maintain battery power, run the engine every 2 to 3 hours for approximately 10 minutes to recharge the battery. The Travel Inverter 120 draws
very low amperage when not in use, and should be unplugged to avoid
battery drain.
USAGE EXAMPLES7.
Device Type Estimated Wattage
Cell Phones, MP3 Players 10 Watts
Portable CD Players 50 Watts
Laptop Computers 90 Watts
Video Games 100 Watts
SPECIFICATIONS8.
Maximum Continuous Power 120 Watts
Surge Capacity (Peak Power) 240 Watts
No Load Current Draw <0.4 Amp, 400mA
Wave Form Modied Sine Wave
Input Voltage Range 10.5 – 15.5V DC
Low Battery Alarm N/A
Output Voltage 110 – 125V AC
Low Battery Shutdown 9.9V – 10.8V DC
High Battery Shutdown 15.0V – 16.0V DC
Optimum Efciency >85%
AC Receptacles One, NEMA 5-15 (USA) 110V AC 3-Prong
USB Port One, 5V, 0.5A
Dimensions 3.75”H x 2.75”W x .875”D
Product Weight Approximately .4 lbs.
Fuse 15 Amp (250V)
• 4 •
Page 7
REPLACEMENT PARTS9.
15 A Fuse: - 3900000190
Power cable: 0699000329
TROUBLESHOOTING10.
PROBLEM: LOW OR NO OUTPUT VOLTAGE
REASON SOLUTION
Poor contact at terminal Unplug and reinsert the Ultra-Slim Travel
Equipment being operated is drawing
too much power
Inverter is too hot (thermal shut down) Allow inverter to cool. Check for adequate
Blown Fuse in Power Cable A blown fuse is usually caused by reverse
Inverter may be defective Call 1-800-SEARS-64 for troubleshooting
Inverter 120.
Use a higher capacity inverter or do not
use the device.
ventilation. Reduce the load on the inverter to rated continuous power output.
polarity or a short circuit within the device
being operated. To replace:
• Disconnect the device immediately.
• Find the source of the problem and
repair it.
• Install a new 15-amp fuse. Do not
tighten the fuse cap too far; nger tight
is sufcient.
NOTE: Installing a fuse higher than 15amps may cause damage to the inverter.
assistance.
• 5 •
Page 8
• 6 •
Loading...