Overview and installation
This manual is provided the instruction in
installation, start-up, operation, maintenance,
cleaning and each operation procedure for
Scotsman NU series ice machine.
Safety instruction
In order to ensure the machine working
normally in long term, please read the manual
carefully and implement strictly before
installation. The producer is not responsible for
any damage or body injury due to ignoring the
safety instructions. If there is any doubt, please
contact the local dealer.
Installation requirements
Please ensure the following items are met
during you determining the installation location:
y Power source: the power switch for the ice
machine should be hand reachable, ensure
that the power supply reliable grounded.
y Water supply: the water supply switch
should be hand reachable.
Water drain: be sure that the drain pipe has
3cm drop per meter.
In order to reach its high performance and
ensure its durability, please pay attention to the
following items:
Operating parameters Lowest Highest
Ambient temperature
10C
(50F)
40C
(100F)
Water inlet temperature 5C (40F) 35C(90F)
Water inlet pressure
1 bar
gauge
5 bar
gauge
Maximum power supply
variation based on the
nameplate
-10% +10%
Orientation and level adjustment
In order to get good ventilation and heat
radiation, the distance between the machine
and the wall, etc. should be more than 150mm.
Don’t hang curtain or pile any goods around the
machine to avoid overheat caused by bad
ventilation, be sure there is no heat source
(such as stove, oven, etc.) around the machine
and the working environment of the ice maker
should not be over humidity.
Before use, install the four supplied legs into
leg acceptor on bottom side of unit base, Level
the unit in both the left to right and front to rear
directions.
Note:
This ice machine is only designed for indoor
installation. For the loss or damage caused by
exceeding the following limited temperature or
involved in the security claims, it is beyond the
general finite warranty clause of Scotsman
producer.
Note:
In order to avoid any infection on the user, the
water for making ice should be the potable
water. If needs, please install water filter or
water processor.