Scitec AEGIS-T,Aegis-T5,Aegis Series User Manual

Aegis Series Telephone

User Manual

Unpacking your telephone:

This package should contain the following:

• Telephone base unit

• Handset

• Coiled handset cord

• Straight line cord

• This manual

5. REDIAL key Automatically hangs up for 1 second before redialing
for convenient “one touch” redialing to busy numbers. (Not available
on Aegis T5 model)

6. STORE and PAUSE keys for programming speed-dial keys.
(Located underneath the faceplate)

7. Ringer volume control Adjust ringer volume from LOW to HIGH.

8. Volume control Key steps through the three available handset

volume levels [Normal – Medium – High -Normal].

9. Slide volume control Separate volume control for speakerphone.

10. Dataport Provides convenient access to the telephone line for

connecting a modem, fax, or answering machine.

11. Hearing aid compatible handset

Speakerphone
[SPKR] key

12. Handset Holder – Clip above the handset used to temporarily
hold up the handset without hanging up in wall mount
applications.

Volume control
[VOL] key

Microphone

13. Half duplex speakerphone. Calibrated for desktop use where
user is within arm’s reach of front of telephone.

Aegis T5

14. LED status indicators

a. A green light indicates the line is in use.
b. A red light indicates that a call in “On Hold”.

*

Feature only available on Memory equipped models.

Features:

Installation

1. Message waiting light and visual ringing indicator compatible with

both AT&T/Lucent LED and high voltage neon message waiting light
systems.

The Aegis Two-line Series telephones are designed for use behind a
registered PBX system. The telephone user or system installer must
supply a RJ-14 two-line modular wall jack to connect this telephone to the
PBX system. The PBX “station port” type must be “Industry Standard
Analog” or “POTS.” This telephone cannot be used with “digital” PBX
station ports.

2. Memory Keys* Up to 10 user programmable speed-dial keys.
16 digit storage capacity per key, including [FLASH] and [PAUSE].

3. FLASH key provides a 600mS (0.6 seconds) flash time. (Not
available on Aegis T5 model)

To install telephone, first snap supplied coiled handset cord into the jack
on the end of handset. Then place the handset in its cradle. Connect the
free end of the coiled handset cord to the jack on LEFT SIDE of the
telephone body, marked with a “handset” symbol.

4. HOLD key for “local hold”.