Scitec 600T,600T5,600TP,800T,800T5 User Manual

U.S. Patent Nos. 6556663, D448011

600 Series Telephone

User Manual

Unpacking your telephone:

This package should contain the following:

• Telephone base unit

• Wall mount adaptor

• Handset

• Coiled handset cord

• Straight line cord

Connect the standard 6-conductor line cord from the telephone system wall
jack to the jack on the rear of the phone.

Features:

Controls, Connections, and Function keys:

(1) Half duplex speakerphone.
(2) LED indicators: line 1, line 2, speakerphone, mute, and conference.

(1) Ringer Volume – Adjusts ringer volume to LOW or HI. Each line has

a separate ringer volume switch.

(3) SiTouch/UnaLight message waiting light and programmable

message retrieval touchbar compatible with both AT&T/Lucent LED
and high voltage neon message waiting light systems.

(2) Handset Holder – Use to temporarily hold the handset without
hanging up when phone is mounted to wall

(4) Flexible dataport.
(5) Speed dial buttons.

(3) Handset Wall Mount Clip – Clip to hold handset on hook when
phone is mounted to wall

(6) Manual Programming of speed dial memory keys and SiTouch

message retrieval key.

(4) Hearing Aid Compatible Handset

(7) Mute, flash, and redial keys.

(5) Handset Jack – Modular jack to connect coiled handset cord from

(8) Store and pause buttons under faceplate.

handset to telephone

(9) Ringer volume controls with separate Hi/Lo setting for each line.

(6) Data Port – Provides direct connection to telephone line for modem,

(10) Handset and speakerphone volume control with four steps.

fax, or answering machine

(11) Three way conference.

(7) [PAUSE] Key – Hidden key (under faceplate) inserts a 2.2 second

pause in stored numbers

(12) Different ringing tone for Line1 and Line 2.

(8) [STORE] key – Hidden key (under faceplate) for manually storing

Installation

numbers in memory keys and [SITOUCH] key.
(9) Memory Keys – Programmable for “one touch” dialing of frequently
used numbers or to add special features available through PBX

function codes

The AEGIS® 600T-T5-TP telephone is designed for use with registered PBX
systems. Determine that you have the correct modular jack for connecting
the telephone. If you do not have a modular jack, one may be obtained at a
minimal cost from a local hardware store or home center.

(10) Dataport switch – Hidden switch (under faceplate) for selecting
telephone line used for dataport
(11) Dial Keys – Oversized keys for easy dialing

No external power source is required for the AEGIS

®

600T-T5-TP 2-line

telephone. This telephone is line-powered.

(12) [VOL] bar – Up/Down rocker key adjusts handset and speakerphone
volume level [Normal – Medium – High– Highest]

(13) [REDIAL] Key – Redials the last number dialed.
(14) [FLASH] Key – Sends a 600ms hookswitch flash to PBX for

accessing special PBX telephone system features.

Insert one end of the coiled handset cord into the small jack marked with the
“handset” symbol on the left side of phone. Insert the other end into the jack
on the lower end of handset.

(15) SiTouch/UnaLight Message Waiting Light [SITOUCH] ­ Also a programmable memory key that activates the speakerphone

2