Schlage KC9000-LG,KC9000 Latch Guard Installation Manual

KING COBRA/KING COBRA-2

NARROW STILE SERIES

KC9000-LG

KC9000 Latch Guard

57055-B 04-2007

KC9000/KC9000-2 LATCH GUARD INSTALLATION

1

1/8” wide blad

Introduction / Tools and Materials Needed / Contact Info

KC9000/KC9000-2 LATCH GUARD INSTALLATION

Introduction / Tools and Materials Needed / Contact Info

Introduction

The KC9000 Latch Guard, when installed in addition to the KC9000 Narrow Stile Trim, adds
an added level of security to outswinging doors. The KC9000 Latch Guard covers the opening
at the critical area between door and frame. Silver coated for environmental protection.

Tools and Materials Needed Not Included in Box:

.Flat head screwdriver w/straight,

2. 1/16” Allen wrench

3. Pencil

4. Center punch

5. Hammer

6. Power drill

7. 1/8” drill bit

8. 7/16” drill bit

9. 11/32” drill bit

10. Drill and Tap for 10-32 threads

11. Socket wrench set

Contact Information:

e

57055-B Page 2 04-2007

Schlage Lock Company

575 Birch Street

Forestville, CT 06010

technical support: 866-322-1237

fax: [phone]

web: http://www.irsupport.net

KC9000/KC9000-2 LATCH GUARD INSTALLATION

Installing the KC9000-LG

Installing the KC9000-LG

1) Prepare Door:

New Construction-Start Here

• Remove all existing trim from outside of door.

• Remove backing from sticky template provided.

• Refer to Figure 1. Apply sticky template to area on stile where

trim

• was removed.

• Center 1-1/4” circle on template with existing cylinder hole (a).

• Use vertical lines on template to insure that template is applied

square to stile.

NOTE: The lines on the edges of template are for vertical guidance only.
Do not line them up with edges of door stile. Template can be lifted and
repositioned as often as required to get the position correct.

• Centerpunch the three small holes on template marked, TAP 10-

32 (b).

• Remove the sticky template.

• Drill and tap (10-32) the three holes (b).

b

a

a

a

b

Figure 1

Retrofit Installation - Start Here

• Refer to Figure 2. Place Latch Guard on door stile and align

with the 3 tapped holes (a).

• Refer to Figures 3 and 4. Outline the two, 3/8” square holes at

the top and bottom of the Latch Guard.

Figure 2

57055-B Page 3 04-2007

Figure 3 Figure 4