Schlage BE467F Installation Manual

*P517-265*

Schlage Control™

P517-265

Model BE467F Installation Instructions

Deadbolt mounting screws

Bolt

Outside assembly

Smart Deadbolt

with Engage Technology

Cover screws

Inside cover

Inside assembly

Credentials not included.

Bolt/Strike

Screws (4)

Strike

Reinforcement plate

Reinforcement screws

Consulte la página 5 para instrucciones en español.
Pour le français, voir à la page 5.

Warnings and Cautions

WARNING

Warnings indicate potentially hazardous conditions, which if not

avoided or corrected, may cause death or serious injury.

Prepare for Installation

Tools Needed

• Phillips screwdriver

• Tape measure

Important Notes

Optional Tools

• Flathead screwdriver

• TorxTM driver

CAUTION

Cautions indicate potentially hazardous conditions, which if

not avoided or corrected, may cause minor or moderate injury.

Cautions may also warn against unsafe practices.

Caution: Cautions indicate a condition that may cause equipment

or property damage only.

WARNING

Install and test lock with door open to avoid being locked in or out!

Caution: Use provided bolt!

Check door dimensions.

See consumer.schlage.com/Service-Support for door preparation
instructions if dimensions are different.

DO NOT use a power drill for installation!

2C\,” OR 2C\v”

Crossbore

Diameter

2Z\,” (53 mm)

(60 mm OR 70 mm)

Backset

1” (25 mm)

Hole

Minimum 4"

(102 mm)

Door Thickness

1C\,” to 1C\v”

2

Install the Lock

1d Install the strike into the frame.

L Install all the parts shown for maximum security.

1 Install bolt and strike.

Caution: Use provided bolt!

1a Adjust bolt length, if necessary.

Measure the backset.

Backset

2C\,” (60 mm)

OR

2C\v” (70 mm)

If the measurement is 2C\v” (70 mm), extend the bolt.

Twist the

faceplate.

Door Stop

Drill pilot holes

Z\,” x 3” deep

2 places

Actual Size (2)

Reinforcement Screws: Actual Size (2)

2 Install the outside assembly.

CAUTION

If the bolt does not remain retracted throughout installation,

locking and unlocking could be reversed, resulting in an

unsecured residence.

2a Install the outside assembly on the outside of the door.

Make sure the button

pops into place.

1b If desired, change to the square-corner faceplate.

1. Use a athead screwdriver to
pry the faceplate off.

2. Press the square-corner
faceplate into place.

1c Install the bolt into the door.

CAUTION

If the bolt does not remain retracted throughout installation,

locking and unlocking could be reversed, resulting in an

unsecured residence.

Make sure the word
TOP faces up when

installing the bolt.

Clips hold the

assembly on the door.

through the slot in the bolt.

Route the cable over

the deadbolt and

through the door.

Route the tailpiece

3 Install the inside assembly.

CAUTION

If the cam is not in the correct position during installation, locking

and unlocking could be reversed, resulting in an unsecured

3a Make sure the cam on the inside assembly is in the correct

position.

residence.

Actual Size (2)

3