Scanwill MP-M technology data

The MP-M

The MP-M

Pressure Intensifier

The MP-M pressure intensifier is an In-Line model, designed to be positioned in a low pressure
hydraulic system, and will provide high pressure exactly where needed. The MP-M will
automatically increase a supplied pressure to the higher end pressure required (max. 800
bar).Having high pressure valves incorporated, including the POV (see page 3), a pilot operated
check valve, for relieving the high pressure side, the MP-M offers a cost effective solution for
intensification needs. Controlling the high pressure side is done by valves on the low pressure
side through the MP-M, allowing the intensifier to be installed in most existing as well as new
hydraulic circuits. The MP-M intensifier is offered with 5 different intensification ratios as standard
with additional ratios on request to meet most intensification requirements.

All connections are 3/8“ BSP

All Dimensions in mm

Filtration Requirement:

10 micron nominal, max. 19/16 according to ISO 4406

Flow & Pressure:

The supplied flow and pressure to the MP-M are dependant on the intensification ratio chosen. The table shows the flow
and pressure for each model. Please note flow values will vary with the viscosity of the fluid. Inlet values must not be
exceeded.

)i(oitaR

8.16.6/0.5223.1/0.593.0/5.1009,2/002022,5/063

4.33.9/0.5323.1/0.547.0/8.2009,2/002068,9/086

0.43.9/0.5360.1/0.436.0/4.2009,2/002006,11/008

0.53.9/0.5339.0/5.305.0/9.1023,2/061006,11/008

0.73.9/0.5308.0/0.343.0/3.1356,1/411006,11/008

wolFtelnI

)MPG/MPL(

1QwolFteltuO

)MPG/MPL(

2QwolFteltuO

)MPG/MPL(

erusserPtelnI

)isP/raB(

erusserPteltuO

)isP/raB(

Ordering Code:

Scanwill

Scanwill

Fluid Power ApS

Example:

MP-M with intensification 4.0: MP-M-4.0

MP- M -

noitacifisnetnI

8.14.30.40.50.7