Scania Removing the xenon lamps Service Manual
Removing the xenon lamps
WARNING!
IMPORTANT!
136 910
1. Cover
2. Lamp
General
• Lethal voltage. Power to the bulb must be turned off when removing. Disconnect
the electrical connection from the lamp unit. Do not touch the bulb with your fingers.
• Wait for at least 3 minutes after switching off the xenon lamp before you start
working. The pressure inside the bulb remains high for a while after the lamp has
been switched off, and the bulb may explode if not handled with care.
Xenon bulbs contain small amounts of mercury. Used xenon lamps must be disposed
of in compliance with local regulations.
General
Work description
12
1. Undo the 4 screws in the headlamp insert.
2. Fold down the wiper arm and take out the headlamp.
3. Unscrew the 2 screws holding the cover inside the lamp insert.
4. Turn the insulator counterclockwise and remove it from the bulb.
5. Remove the spring holding the bulb, and remove the bulb.
136 909
03:48-00 Issue 1 en-GB 1 (1)
©
Scania CV AB 2012, Sweden
Loading...