Scania Removing the turbocompound unit Service Manual
Removing the turbocompound unit
Work description
Work description
Remove the parts in the order below:
1. Exhaust pipe
2. Union on the pipe to the exhaust brake
3. Clamp
4. Bracket
5. V-clamp
6. Bracket
7. Pipe bend screws at the exhaust brake damper housing
8. Pipe bend
There is a guide pin between the exhaust brake damper housing and the turbocharger. Separate the damper housing and the turbocharger, then turn the damper
housing towards the engine so that the pipe bend does not contact the exhaust
brake air cylinder.
9. Exhaust brake damper housing
10. Oil pipe
Remove the clamp and the lower connection. Detach the upper connection a few
turns and place the pipe to one side.
11. Turbocompound unit front retaining screws. 2 off
12. Place a strap around the turbocompound unit and lift carefully until the strap is
tensioned.
13. Turbocompound unit rear retaining screws
14. Turbocompound unit
14
3
13
1
10
12
11
2
4
5
7
6
8
9
03:84-00 Issue 1 en-GB 1 (2)
©
Scania CV AB 2012, Sweden
333 310
Removing the turbocompound unit
WARNING!
The turbocompound unit tilts when being removed from the timing gear plate.
Work description
03:84-00 Issue 1 en-GB 2 (2)
©
Scania CV AB 2012, Sweden
Loading...