Page 1
Removing the silencer
Work description
1. Tilt the cab.
2. Remove the mudguard and side panel.
3. Remove the side skirt.
4. Remove the heat shield for the incoming exhaust pipe and catwalk.
5. Undo the incoming exhaust pipe V-clamp, see illustration.
Position a height-adjustable trolley (for example Scania part number 588 084) or
similar under the silencer to prevent it from falling when exhaust pipes and
brackets are detached.
1
Work description
327 410
1. Vehicles with side skirts
03:88-00 Issue 1 en-GB 1 (4)
©
Scania CV AB 2012, Sweden
Page 2
Removing the silencer
6
6. Detach the interface for electrical components.
7. Undo the V-clamp and the bracket screws. Remove the NOx sensor if the exhaust
pipe discharges on the left-hand or right-hand side. Remove the outgoing exhaust
pipe; see figure under point 4.
Work description
03:88-00 Issue 1 en-GB 2 (4)
©
Scania CV AB 2012, Sweden
Page 3
Removing the silencer
8. Slacken off the screws for the lock washers and then slacken off the screws se-
curing the silencer.
Work description
03:88-00 Issue 1 en-GB 3 (4)
©
Scania CV AB 2012, Sweden
Page 4
Removing the silencer
9. Remove the silencer.
First pull the silencer out about 20 centimetres and detach the reductant hoses
from the silencer.
Use a height-adjustable trolley (for example Scania part number 588 084) or similar on which to pull out the silencer. Secure it so that it cannot roll off.
Work description
03:88-00 Issue 1 en-GB 4 (4)
©
Scania CV AB 2012, Sweden
Loading...