Saturn Equipment UFT1R-1 Installation Manual
URT1R-1, URT2R48-1, URT2R-1, URT3R-1,
UFT1R-1, UFT2R48-1, UFT2R-1
WORKTOP UNITS
INSTRUCTION MANUAL
This manual contains important information regarding your Supera® unit. Please read this manual thoroughly prior to equipment set-up, operation and maintenance. Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty.
Please read the manual carefully and
follow all
instructions. Failure to do so may void your warranty.
The manufacturer cannot be held liable i
n the
following cases:
Improper installation and servicing
•
Misuse of the refrigerator
•
Improper or inadequat
•
Unauthorized modification or
•
Use of non-original spare parts
•
Partial or total failure to comply
•
e maintenance
tampering
with the instructions
TRANSPORTATION
Unit may not be placed on its side for any reason during shipping.
It should be stored in a protected and covered environment at a
temperature between -25°C and
of 30% to 90%. Do not stack more than 4 units high.
55°C with an ambient humidity
INSTALLATION AND SET UP
MANUAL
INSTRUCTION
•
•
•
•
•
©SUPERA
UNIT MUST RUN FOR 24 HOURS BEFORE USING!
The unit
cardboard box and strapped on a wood pallet. Remove all
straps and packaging, including the PVC protective film. If
damage is noted, file a claim immediately.
Install the units on a level surface. If the
the legs can be adjusted.
Make sure that it
There should
there is proper air circulation for the condensing unit.
Before use, the interior
with a soft cloth.
•
is wrapped in absorbent material inside a
surface is not level,
is not placed in direct sunlight or by a heat source.
be 5cm clearance from wall and unit so that
and exterior should be cleaned
Do not use an abrasive cleaner or scour pad!
V.1.0 | October 2014
CONNECTING TO THE MAIN POWER SUPPLY
Before plugging in, make sure that the main power
•
source is grounded properly and matches the voltage
ratin
Do not in any way remove the ground prong.
•
Always make sure that the power cord is
•
g of that of the unit (found on the rating label).
condition, is not frayed and does not show abrasion.
Do not use an extension cords or adapter plugs and only
•
plug in one un
When plugging and unplugging, do s
•
Plug in the unit and
•
it per circuit.
adjust the thermostat to your
desired temperature.
MAINTENANCE AND CLEANING
Regular cleaning of the
month.
Before cleaning, power
•
Clean the exterior and interior with a
•
soft cloth. Do not use abrasive detergents and cloths!
unit is strongly recommended each
off and unplug the unit.
in good
o by gripping onto the plug.
MANUAL
INSTRUCTION
mild detergent and
Cleaning the Condenser
The condenser should be thoroughly cleaned every 4
•
months or when the fins get dirty
dry brush or a vacuum cleaner.
©SUPERA
. It can be cleaned with a
V.1.0 | October 2014
Loading...