Sanyo VA-80BW Instruction Manual

INSTRUCTION MANUAL

Wall Mounting Bracket

This installation should be made by a qualified service
person and should conform to all local codes.

About this manual

This bracket is designed for ceiling mounting installation.
Before installing and using this unit, please read this manual carefully.
Be sure to keep it handy for later reference.

CAUTION:

Install this bracket securely according to this
installation manual. Be aware that allowing the
bracket to fall with the camera on it may cause
personal injury.

VA-80BW

English

Example of

indoor use

☞P1 ☞P2

Example of

outdoor use

Important

• Be careful when opening holes for installing the
unit. Work with the power and video cables pulled
out for easy installation.

• Make sure to properly perform waterproofing for the
wall where you are installing the unit.

• Make sure that the surface in the installation
location has no unevenness and is strong enough
to bear the total weight of the unit.

• Install this unit in an environment where the
temperature range stays between -30°C and +50°C
(-22°F and +122°F) (no condensation allowed).

bSpecifications

Color: Beige
Material: Metal
Waterproof Standard: Conforming to IP66
Weight: Approx. 750 g (1.7 lb)

Allowable Load: Max. 20 kg (44.1 lb)

Dimensions:

240 (9.4)

192 (7.6)

56 (2.2)

17(0.7)

Ǿ97 (3.8)

日本語

Accessories (For outdoor housing)

Bolts, washers Rubber band

Features and specifications are subject to change without
prior notice or obligations.

161 (6.3)

191 (7.5)

75 (3.0)

105 (4.1)

4-Ǿ10.8 (0.4)

Unit: mm (inch)

Indoor Type

Make sure to also consult the relevant instruction manuals.

Mark the locations on the wall and drill the

1

holes for the cables and screws.

And pull out the cables from the wall hole and
pass them through the bracket as shown in
the figure.

Fix the bracket to the wall using commercially

2

available screws (A) in 4 places.

M8 (5/16”): 40 mm (1.6”) or more

Connection cables

A

Video cable

A

Mount the power board unit onto the

3

attachment.

(1)Pass the screws supplied with the

attachment through each of the power board
unit screw holes (B) and fasten them loosely
using washers (4 places).

(2) Align the blue sticker (C) on the attachment

and the arrow (C) of the same color on the
power board unit, and tighten firmly the
screws loosely fastened in the previous
step.

With sticker (D) facing toward you, fix the

4

attachment onto the bracket using the 4 bolts
(E) supplied with the attachment.

• To fix the attachment, use the hexagonal
wrench supplied with the attachment.

• Make sure that the attachment is fixed, then
peel-off the sticker.

Connect the cables to the power board unit

5

and mount the camera unit onto it.

☞ For details, please refer to Installation Manual that

comes with the camera unit.
“Connections and Settings”
“Surface Mount”

3

C; Blue

B

B

B

Power Board Unit:
VA-84S/80S

B

a

b

Attachment: VA-80A

E

E

D

• Be sure to fix the bracket securely using M8 (5/16”)
screws. Using other bolt sizes may cause the
bracket to fall together with the camera on it.

• Route the connected cables so that they do not
touch the power board unit and other parts.

Screws, washers

(for power borad

1

Attachment accessories

b

E

a

Bolts (10 mm/0.4”)

unit)

Hexagonal

wrench