Sanyo VA-30F(GB) Instruction Manual
INSTRUCTION MANUAL
MOUNTING BRACKET
HANGING TYPE
VA-30F
Specifications
Weight : Approx. 600 g
Cover plate diameter : 222 mm
Color : Ivory
Features and specifications are subject to change without prior notice or
obligations.
Before starting the installation procedure, please read these instructions carefully. Make sure to keep
these instructions handy for future reference.
This ceiling mounting bracket is for use when installing dome-type cameras to a ceiling. When installing
such cameras, make holes in the ceiling and then securely install the ceiling mounting bracket into these
holes.
Safety Precautions
This indicates a point that if not respected may cause
WARNING
Installation location strength check
Confirm that the selected location can support the total weight of the camera and the mounting
bracket. A weak installation location can cause the camera and support to fall down.
For strong installation, reinforce gypsum board, ceiling tiles, etc. Make sure the mounting
bracket is firmly attached or else the camera and mounting bracket may fall.
death or serious injuries.
Installation
Take the four accessory 60-mm long
1
screws D for installing the camera and
provisionally install them to the ceiling
mounting bracket A.
Make a hole with a diameter of about 110
2
mm in the ceiling, and then pass the
anchor bolt through the center section as
shown in Figure 1. Securely tighten this
anchor bolt to the ceiling mounting bracket
A. Then attach the accessory safety wires
E as shown in Figure 1.
Securely install camera mounting bracket
3
B to the camera using the four accessory
12-mm long screws C as shown in Figure
2.
Pull out the safety wire (with the rounded
4
end) from the ceiling mounting bracket A,
lift up the camera, and then insert the
safety wire into the wire fixing slot in
camera mounting bracket B until it clicks
into place.
Pass the four screws D that are attached
5
to the ceiling mounting bracket A through
the four holes in camera mounting bracket
B as shown in Figure 3, and move them
toward the narrow ends of the holes.
Adjust the four accessory 60-mm long
6
screws D with a screwdriver so that the
camera is fully flush with the ceiling.
Lastly, push both hooks on the underside
7
of veneer plate F into the holes in camera
mounting bracket B until they snap into
place.
1
Existing
anchor bolt
2
anchor
bolt
E
φ110mm
B
A
D
100 mm or more
40 mm or less
E
A
C
D
B
3
F
This indicates a point that if not respected may cause
CAUTION
injuries and/or extensive material damage.
Consult your dealer for installation
The installation requires certain knowledge and experience and should be referred to a
professional. If the support and/or camera fall they may cause severe injuries.
Do not let the bracket and camera dangle from the cable
During installation, do not let the bracket and camera dangle unsupported from the cable.
If not, they may fall and cause severe injuries.
1AC6P1P2596-L9BDK/WA(0402KP-CZ)
SANYO Electric co Ltd.
Printed in Japan
Loading...