Sanyo VA-22P Instruction Manual

SPECIFICATIONS

Materials : Galvanized steel plate and ABS plastic Ambient temperature : –10 ~ +50˚C Dimensions : Refer to the dimension diagram below.

* The length of the support pole will vary according to customer

specifications.

Weight : Approx. 1.2 kg Accessories : M4 x 12 screws (3 pcs.)

Appearance and specifications are subject to change without notice.

Dimensions

100mm

32mm

88mm

1AC6P1P2415-L9BBE/XE (0011KPS)

SANYO Electric Co., Ltd.

Printed in Japan

INSTRUCTION MANUAL

VA-22P

Pendant Ceiling Bracket

If the pendant ceiling bracket is not installed in the correct position, or if it is connected incorrectly, it may result in fire or electric shocks. In some cases severe injury or death may also result.

Install in a location which is strong enough to support the combined weight of the

•

camera and the pendant ceiling bracket for many years.

To prevent the possibility that the camera and pendant ceiling bracket may fall down, suspend a weight of 5 kg or more from the intended installation location using a metal chain or wire, and check that safety can be maintained.

Leave at least 1.5 m of space between the pendant ceiling bracket and air outlets

•

from equipment such as air conditioners.

If cold air is allowed to blow directly onto the camera, it may cause the lens to become cloudy, and this can adversely affect the quality of the recorded images.

Avoid installing the pendant ceiling bracket directly underneath ceiling water pipes

•

or places which might be subject to water leakage.

Condensation from water pipes may get inside the camera and cause fire or electric shocks.

Avoid places which are subject to vibration or noise.

•

Vibration and loud noise can cause the screws to loosen, which might damage the bracket or cause the camera and bracket to fall down. Furthermore, it may also cause the screen to shake and result in synchronization problems.

Be sure to use only the provided screws for installation.

•

Do not disassemble or modify the pendant ceiling bracket.

•

Failure to observe this may cause the bracket to become damaged or fall down.

INSTALLING THE BRACKET AND CAMERA

After installing the bracket and camera, check that they are securely installed so that there is no danger they will fall down.

1 Make three M8 or M10 holes A in the

location where the bracket will be installed, such as a ceiling reinforcement plate.

2 Align the holes in the flange B with the

mounting holes in the ceiling, and then secure the pendant ceiling bracket with M8 or M10 bolts.

Caution

Make sure that the bolts are securely tightened. After tightening the bolts, paint them to prevent them from loosening.

3 Pass the cables which are to be connected to

the camera through the cable hole C and the support pipe D.

4 Secure the fitting E to the camera with the

120mm

three screws F (M4x12) which are provided.

5 Connect the power supply, RS485 and signal

cables to the connection terminals on the camera.

Refer to the Instruction Manual for the camera for details on connecting each of the cables.

Caution

After installing the bracket and camera, paint the bolts to prevent them from loosening.

6 Install the cover G.