The LA4282 is an IC which seals a high-output power
amplifier for TVs and monitors in a compact package.
Package Dimensions
unit : mm
3049A-SIP12H
[LA4282]
Features
.
High-power 2-channel AF power amplifier
.
Low distortion
.
Minimum number of external parts required
(no bootstrap capacitor required)
.
Low pop noise at the time of power supply ON/OFF
.
Good ripple rejection (58 dB typ)
.
Wide operating voltage range
.
External muting available
.
On-chip protector against abnormality
(thermal shutdown, overvoltage)
SANYO : SIP12H
Specifications
Maximum Ratings atTa=25°C
ParameterSymbolConditionsRatingsUnit
Maximum supply voltageV
Maximum output currentI
Allowable power dissipationPd maxWith heat sink25W
Operating temperatureTopr–20 to +75°C
Storage temperatureTstg–40 to +150°C
Equivalent Circuit Block Diagram and Pin Assignment
CCO
I
(2)Muting switch On3056100mA
CCO
P
(1)THD = 1%9.010.0W
O
P
(2)THD = 3%10.011.5W
O
NO
O(MT)
= 2 W0.050.20%
O
Rg=10kΩ, BW = 20 Hz to 20 kHz0.251.0mV
= 100 Hz, VR= 0 dBm4558dB
R
Muting switch On, VIN= –5 dBm–35dBm
No.2683-2/6
Page 3
Test Circuit
LA4282
Polyester film capacitor
–W
O
With arbitrarily large heat sink
With 200 × 200 × 1.5 mm3Al board
With 100 × 100 × 1.5 mm
With 50 × 50 × 1.5 mm
Independent IC
Allowable power dissipation, Pd max − W
Ambient temperature, Ta − °C
3
Al board
3
Al board
Tightening torque 39Nccm
With
silicone
grease
applied
–W
O
Output power, P
Supply voltage, VCC–V
Output power, P
Supply voltage, VCC–V
No.2683-3/6
Page 4
LA4282
–W
O
Output power, P
− dBm
O
Output signal level, V
Noise level
Frequency,f–Hz
Mute OFF
=8Ω)
(R
L
Mute ON
–W
O
Output power, P
Frequency,f–Hz
–W
O
Output Power, P
Input voltage, VIN− dBm
Total harmonic distortion, THD – %
Total harmonic distortion, THD – %
Output power, PO–W
Input voltage,VIN–mV
Frequency,f–Hz
Response – f
–A
CC
Response – dB
Current dissipation, I
Frequency,f–Hz
Output power, PO–W
No.2683-4/6
Page 5
–W
O
Output power, P
Supply voltage, VCC–V
LA4282
Allowable power dissipation, Pd – W
Output power, PO–W
Allowable power dissipation, Pd – W
–mV
Output noise voltage, V
–mV
NO
RO
Output power, PO–W
BW=20Hzto20kHz
Signal source resistance, Rg − Ω
Allowable power dissipation, Pd – W
Output power, PO–W
– mVms
RO
Output ripple voltage, V
Ripple voltage, VR– Vrms
Crosstalk, C.T – dB
Output ripple voltage, V
Supply voltage, VCC–V
Frequency,f–Hz
No.2683-5/6
Page 6
LA4282
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1 Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of February, 1996. Specifications and information herein are subject to change without notice.
No.2683-6/6
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.