Quick Start Guide
50169323
CE32LD08DV-B
Insert the batteries into the handset
1
Insert two AAA/R3 or
equivalent type batteries
inside. Observe the
correct polarity (+/-) when
inserting batteries and
replace the battery cover.
Connect the aerial straight to your TV
2
75
VHF/UHF
REAR OF THE TV
Connect the TV to the mains socket
3
UK plug
CABLE TV
To switch the TV on
4
1. Press the On/Off switch at the side of the TV. The TV
switches itself to standby mode and the light will illuminate
on the front of the TV.
2. Switch television on from stand-by, by pressing the standby
button on the remote control,the standby button on the TV or
one of the 0…9 buttons on the remote control. Press P/CH- or
P/CH+ button on the TV or press the P+ or P- button on the
remote control.
Start Auto Setup procedure
5
1. When the TV is turned on for the fisrt time, the menu for the
language selection appears on the screen.the message “Welcome
please select your language!”Is displayed in all language options
sequentially in the OSD.By pessing the “ ” or “ ” buttons highlight
the language you want to set and press OK button.
2. By pressing “ ” or “ ” buttons, set active antenna mode as on or
off.If an active antenna is connected to your TV, you can select this
option as On. Antenna power should be “Off” when standard
antenna is used instead of the active antenna. See Configuration
Menu in the following sections for more information.
RETURN
MENU
3. After Automatic search is complete, the following message
asking for analogue channel search appears on screen.
4. Press OK/Select button to start installation.
5. Check Language and then press OK/Select.
Important note: After the APS has finished, the
program table will appear on the screen. The
stored local channels are automatically assigned
a programme number. If you would like to change
the programme order, please refer to the Program
Menu section of the instruction book.
DVD Playback
6
When TV set is on, insert a disc into the loader at the side of the unit.
(Disc label facing the front) the disc will be automatically loaded, a
menu may appear on the TV screen after a few moments or the film
may start immediately depending on the disc content. To start DVD
playback press play button on remote control.
insert plug...
...and switch on
Loading...