Sanus Systems NFCD User Manual

Assembly Instructions for Model: NFCD

Thank you for choosing a Sanus Systems Natural Media Tower. The Model
NFCD is designed to keep your collection clean and organized by storing up to
430 CDs or 230 DVDs, all in one convenient location.

If you do not understand these directions, please contact Sanus at 800.359.5520
or www.sanus.com. Check carefully to make sure that there are no missing or
defective parts. Our customer service representatives can quickly assist you
with assembly questions, and missing or damaged parts. Replacement parts
for products purchased through authorized dealers will be shipped directly to
you. Never use defective parts. Improper assembly may cause damage or
serious injury. Do not use this product for any purpose that is not explicitly

specied by Sanus Systems. Sanus Systems can not be liable for damage

or injury caused by incorrect assembly, or incorrect use. Please call Sanus
Systems before returning products to the point of purchase.

Required Tools: Rubber mallet or hammer, screwdrivers, phillips & regular

Supplied Parts List: (Not to Scale)

NFCD Top - A

Qty. 1

NFCD Base - B

Qty. 1

NFCD Foot - C

Qty. 4

Glass Shelves - F

Qty. 14

Sanus Name Plate - G

Qty. 1

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02.28.06 (100028)

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Center Support - D

Qty. 1

Side Panels - E

Qty. 2

Supplied Hardware: (Full Size)

Cam - H

Qty. 4

Machine Screw - K

Qty. 4

Step 1 - Attach Feet to NFCD Base

Insert a Machine Screw (K) into each Foot (C); then using the regular screwdriver, attach the Feet to the NFCD Base (B).

Cam Pin - I

Qty. 4

Wood Screw - L

Qty. 4

Diagram 1

Plastic Dowel - J

Qty. 4

Shelf Pin - M

Qty. 56

B

C

C

C

K

K

C

K

K

Step 2 - Insert Cam Pins into Side Panels

There are two holes that are centered on each side of the Side Panels (E), and 12” [304.3 mm] from each end. Using
the phillips screwdriver, screw Cam Pins (I) into the two holes of each Side Panel taking care not to over tighten the Cam

Pins.

Diagram 2

E

E

I