Samsung WT90H2P, WT90H2EW/XSG, WT90H2, WT80H2, SWT80H2 User Manual

BEFORE USING THE WASHER

In case of pump drained washer,
remove the cap-hose from the drain hole.

CAUTIONS

To avoid electrical shock,use a metal pipe for the ground connection. But, don't ground the washer with gas pipes or telephone lines to avoid dangers of explosion or lightning strike.
Do not put your hands into the spin
dryer basket when it is spinning.
Y our fingers can be caught by spinning laundry and damaged.
Never allow children to operate
or play with the washer.
Children playing with the washer may accidentally fall into the washing tub.
Disconnect the power cord from the
power supply when not in use.
Ventilation
by carpeting when the washing machine is installed on a carpeted floor.
If the supply
it must only be replaced by a repair shop appointed by the manufacturer,because special purpose tools are required.
Warningto avoid overfilling and damages
this appliance must be filled with the operator present using a moderate water supply pressure only.
If the supply cord is damaged, it must be replaced by the munufacturer or its service
agent or a aimilarly qualified person in order to avoid a hazard.
The appliance is to be connected to the water mains using new hose-sets and that old hose-
sets should not be reused.
For washing machines with ventilation openings in the base, that a carpet must not
obstruct the openings.
opening must not be obstructed
cord of this appliance is damaged,

PRECAUTIONS WHEN OPERATING

Don't use excessively hot water. (50˚C or more)
Plastic parts may be deformed or damaged. Also, clothing may be deformed or decolored.
Before washing,check all pockets.
If nails or pins remain in pockets,they may damage the washer or clothes.
Close the water tap a little if the
water pressure is too high.
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from being tossed out and damaged.
To avoid water splashes,
close the wash tub lid.
Be sure lay the drain hose down (in case no drain pump)
Never splash water on the control panel.
1

DESCRIPTION OF PARTS

SPIN DRYER LID
When you open this lid while the spin basket is spinning, the spinning will be stopped by brake system.
INNER LID
DRAIN HOSE
(WITH PUMP)
LINT FILTER
WASH TUB
WASH TUB LID
Be sure to keep the lid closed during washing
and spinning.
WATER DRAIN HOSE
(WITHOUT PUMP)
1. WASH
SELECTOR
This is used to select wash action.
2. WASH TIMER
This is used to set the wash time, 1-15 minutes.
3. CYCLE SELECTOR
This is used to select the Washing /
Rinsing or draining
POWER CORD
The plug’s shape may not correspond with this drawing.
SPIN DRYER BASKET
PULSATOR DRAIN FILTER
(with pump)

CONTROL PANEL

4. SPIN DRY TIMER
This is used to set the spin time, 1-5 minutes.(or 1-10 minutes)
5.WATER SELECTOR
During washing,WATER SELECTOR KNOB should
be selected to wash.During spin rinsing,WATER SELECTOR KNOB should be selected to spin.
1 2 5 3 4
2

W ASHING PROCEDURE

TO WASH
1. Before starting washing, check the following;
Connect the water supply hose and open the water tap.
- Lay the drain hose down toward a sinkhole. (In case no drain pump)
- Place the drain hose in sink or bath. (In case drain pump)
-Connect the power cord to the power supply outlet .
2. Set the WASH SELECTOR KNOB to the desired mode.
6. Fill water in the wash tub and add the detergent.
7. Set the WASH TIMER 1-15minutes.
3. Set the CYCLE SELECTOR KNOB to
4. Set the WATER SELECTOR
5. Load laundry in the
WASH
KNOB to WASH .
RINSE’. (In case drain pump WASH”)
wash tub.
FOR B TYPE
SPIN DRY
1. Transfer the clothes into the spin basket and arrange the clothes evenly.
close the inner lid.
8. After washing,set the CYCLE SELECTOR KNOB to ‘DRAIN’ for drain.
3. Close the spin dryer lid.
4. Set the SPIN DRY TIMER 1-5minutes.2. Be sure to attach the safety cover and
(or 1-10minutes)
inner lid
safty cover
3
Loading...
+ 5 hidden pages