Page 1
BEFORE USING THE WASHER
DESCRIPTION OF PARTS
▶ Remove the cap-hose from the drain
hose.
CAUTIONS
▶▶
Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
▶▶
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
▶▶
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
▶ In case of pump drained washer,
remove the cap-hose from
the drain hole.
▶▶
Disconnect the power cord from the
power supply when not in use.
▶▶
Ventilation
by carpeting when the washing machine is
installed on a carpeted floor.
▶▶
If the supply
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
▶▶
To
must be filled with the operator present using a
moderate water supply pressure only.
opening must not be obstructed
cord of this appliance is damaged,
avoid overfilling and damages this appliance
Otherwise,excessive vibration
CONTROL LEG
Adjust the control leg
and noise can occur
for even placement.
during spinning
Be sure to keep the lid
closed during washing
WASH TUB LID
and spinning.
during washing.
the dregs which are made
This is used for gathering
LINT FILTER
OVER FLOW
FILTER
SPIN DRYER LID
When you open this lid while
the spinning will be stopped
the spin basket is spinning,
by breake system.
PRECAUTIONS WHEN OPERATING
▶▶
Don't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
▶▶
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
▶▶
Close the water tap a little if the
water pressure is too high.
▶▶
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
▶▶
To avoid water splashes,
close the wash tub lid.
▶▶
Never splash water on the control panel.
1 2
PULSATOR
WATER DRAIN HOSE
(WITHOUT PUMP)
EARTH WIRE
(Option)
POWER CORD
The plug’s shape
may not correspond
with this drawing.
WASH TUB
SPIN DRYER HATCH
SPIN DRYER BASKET
DRAIN HOSE
(with pump)
INNER LID
Page 2
1 2 3 4 5
CONTROL PANEL WASHING PROCEDURE
SWT90C1(P) / SWT90C2(P)
WT10S0(P) /WT10S1(P) /WT10S2(P)
11..
WATER
22..
WASH TIMER
33..
WASH
SW-903(P)
11..
WASH TIMER
22..
WASH CONTROL
33..
SPIN DRY TIMER
SELECTOR
During washing, WATER SELECTOR KNOB
should be selected to wash. During spin rinsing,
WATER SELECTOR KNOB should be selected to spin.
This is used to set the wash time, 1-15 minutes.
SELECTOR
You can wash laundry effectively by various methods.
(B)Type
This is used to set the wash time, 1-15 minutes.
You can wash laundry effectively by various methods.
This is used to set the spin time 1-5 minutes.
FRONT PANEL
(A)Type
44..
CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
55..
SPIN DRY TIMER
This is used to set the spin time 1-5 minutes.
44..
WATER INTAKE
Connect water inlet to a tap with a suitable.
DRAIN SELCTOR
55..
Be sure to press the selector knob to ‘WASH’ while washing.
TO WASH
Before starting washing, ; Connect the water supply hose and open the water tap.
check the following - Lay the drain hose down toward a sinkhole.(In case no drain pump)
(A)Type
1. Set the CYCLE SELECTOR KNOB to
‘‘
WASH••RINSE
2. Set the WATER SELECTOR
KNOB to WASH .
3. Select the
WASH SELECTOR KNOB
for desired mode.
4. Fill water in the wash
tub to the‘‘L1’’lower
water level by carefully
adjusting the tap water
and add the detergent.
5. Put the cloths into
the wash tub and
set the same water
pressure to fill the
tub so as not to
exceed ‘H3’level.
’’..
(in case drain pump “WASH”)
- Place the drain hose in sink or bath.(In case drain pump)
- Connect the power cord to the power supply outlet .
(B)Type
1. Select the WASH CONTROL KNOB
for desired mode.
2. Press the
DRAIN SELECTOR KNOB
to ‘WASH’ .
3. Fill water in the wash tub
to the‘‘L1’’lower water
level by carefully
adjusting the tap water
and add the detergent.
4. Put the cloths into the
wash tub and set the
same water pressure
to fill the tub so as not to
exceed ‘H3’level.
5. Set the WASH TIMER
1-15minutes.
REAR PANEL
3 4
6. Set the WASH TIMER
1-15minutes.
7. After washing, set the
CYCLE SELECTOR KNOB
to ‘DRAIN’’for drain.
6. After washing Press the
DRAIN SELECTOR KNOB to
‘DRAIN’ for drain .
Page 3
WASHING PROCEDURE
SPIN DRY
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
close the inner lid.
inner lid
safty cover
3. Close the spin dryer lid.
4. Set the SPIN DRY TIMER 1-5minutes.2. Be sure to attach the safety cover and
RINSING
(A)Type (B)Type
1. Set the CYCLE SELECTOR KNOB to
‘‘
WASH RINSE
2. Supply the proper amount of water as not
to overflow the top of the washing tub.
’’..
(In case drain pump ‘WASH’)
1. Press the DRAIN SELECTOR
KNOB to ‘WASH’.
2. Supply the proper amount
of water as not to overflow
the topof the washing tub
and put the laundry
into the washing tub.
OVER FLOW RINSE
(A)Type (B)Type
1. Keep suppling water(adjust water pressure
to ensure that the amount of water supplied
does not exceed that water drained.)
2. Set the WASH
TIMER 6~8minutes.
3. As soon as the WASH TIMER
shuts off, turn off the water tap.
4. Set the CYCLE
SELECTOR KNOB
to‘‘DRAIN
ADDITIONAL RINSE
’’..
(SHOWER RINSE FOR )
(A)Type
1. Keep suppling water(adjust water pressure
to ensure that the amount of water supplied
does not exceed that water drained.)
2. Set the WASH
TIMER 6~8minutes.
3. As soon as the WASH TIMER
shuts off, turn off the water tap.
4. Press the DRAIN SELECTOR
KNOB to ‘DRAIN’.
3. Set the WASH TIMER
2~3minutes.
4. Drain the water.
Set the CYCLE SELECTOR
KNOB to ‘‘DRAIN
5. Repeat this cycle until drain water
is clean. (2~3 cycle)
’’
3. Set the WASH TIMER
2-3 minutes.
4. Drain the water.
Press the DRAIN SELECTOR
KNOB to ‘DRAIN’ .
5. Repeat this cycle until water
becomes clean.(2-3cycle)
After rinsing you can select this
course for more effective rinse
1
(Don't select only this course
for rinse.) Load the laundry
evenly into the spin basket.
Set the WATER SELECTOR KNOB to
2
SPIN and CYCLE
SELECTOR KNOB to
‘DRAIN’.
Supply water for about 1minute.
3
Adjust the water flow to prevent
overflow from the wash tub.
5 6
inner lid
safety cover
After stopping water
4
supply, cover the
laundry with safety cover
and close the inner lid.
Close the spin dryer
5
lid.
Set the SPIN DRY
6
TIMER 2~3 minutes.
Page 4
INSTALLATION
2
1
70~80cm
Rag
Close
Open
Filter
LAUNDRY GUIDE
ENVIRONMENT
Leave some space
Space at last 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2°)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about
70~80cm above the ground
for pump model.
CHANGING THE POSITION OF THE DRAIN HOSE
Before attempting to change the position of the drain hose,
disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and
HOW TO CLEAN THE FILTER (In case drain pump)
1.
2.
3. Remove dirts and rotate
CLEANING THE MACHINE
insert the drain hose into the hose holder.
Place a rag under the washer filter
not to wet the floor.
Rotate the filter counterclockwise
and pull out the filter.
the filter clockwise until it
locks in position.
Hose holder
AMOUNT OF CLOTHES
Water Level
Shirts(Synthetics)
Under Shirts(Cotton)
Working clothes(Cotton)
Low
22 Pieces
38 Pieces
16 Pieces
29 Pieces
48 Pieces
20 Pieces
DETERGENT
AMOUNT OF
DETERGENT
44g
56g
67g
-The amount of detergent is average.
Follow the instruction detergent printed on the package for
amount of detergent.
-Choose the amount of detergent depending on the fabric type.
WHEN YOU LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket drum as shown in
the figure.
WATER
LEVEL
Low(44ℓ)
Middle(56ℓ)
High(67ℓ)
Middle
High
35 Pieces
58 Pieces
25 Pieces
SPIN DRY TIME
TYPE OF LAUNDRY
TIME
1min.
1~2min.
3~5min.
5min.
Thin(synthetic fiber)
wool
cotton
thick(cotton)
MAINTENANCE
TO PICK OUT THE CLOTHING WHICH HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safty, pull the power supply plug out of the socket.
1.Disassemble two screws from the spin dryer hatch.
2.Pull up the spin dryer hatch to remove it.
3.Remove the clothing.
4.Close the spin dryer hatch.
1. OVERFLOW FILTER
Pull the upper side of the
overflow filter with
your fingers into the holes
in the direction of arrow as
shown in the figure.
3. CLEANING THE WASHER BODY
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene,thinners,cleanser,or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
2. CLEANING THE FILTER
Pull the overflow filter out and take up the filter
by removing 3 screws as shown in figure.
Wash the filter and washing tub.
TROUBLE SHOOTING
TROUBLE
The washer
does not work.
Clothes will
not move freely.
Incomplete
spinning
CHECK POINT
Check that the power cord is
connected to a power outlet well.
Power stoppage?
Is the laundry overloaded?
Are the laundry arranged evenly?
TROUBLE
Incomplete
draining
The spin dryer
basket will not
run.
7 8
CHECK POINT
filter clogged
Is the
with lint?
▶▶
See “Cleaning the
machine” on page 7.
Is the spin dryer lid closed
completely?
Are laundry(socks,etc.)falling
out of the spin dryer basket and
clinging to the axle?
““
▶▶
See
To pick out...””on page 8.
Page 5
Owner’s Instructions
SW-903(P)/SWT90C1(P) / SWT90C2(P)
WT10S0(P) /WT10S1(P) /WT10S2(P)
IF YOU NEED HELP.
Do not hesitate to call your local samsung service center.
They will be willing to help you.
Be sure to give them your name,address,telephone number and the purpose of the call.
Before operating the unit, please read this manual
throughly, and retain for future reference.
BEFORE USING THE WASHER 1
CAUTIONS 1
PRECAUTIONS WHEN OPERATING 1
DESCRIPTION OF PARTS 2
CONTROL PANEL 3
WASHING PROCEDURE 4
TO WASH 4
SPIN DRY 5
RINSING 5
OVER FLOW RINSE 6
ADDITIONAL RINSE 6
INSTALLATION 7
ENVIRONMENT 7
CHANGING THE POSITION OF THE DRAIN HOSE 7
HOW TO CLEAN THE FILTER 7
CLEANING THE MACHINE 7
LAUNDRY GUIDE 8
MAINTENANCE 8
TROUBLESHOOTING 8
SPECIFICATIONS
SWT90C1(P) / SWT90C2(P)
DIMENSIONS
(mm)
SW-903(P)
WT10S0(P) /WT10S1(P) /WT10S2(P)
WATER PRESSURE
WEIGHT
EXTRACTION EFFICIENCY
STANDARD QUANTITY OF WATER
RATING TIME
SPECIFICATION
W820mm××D524mm××H1000mm
W820mm××D524mm××H920mm
W820mm××D524mm××H993mm
0.05~0.78 MPa
0.5~8.0
kg .f/cm
36kg
50 %
Low : 44ℓℓMiddle : 56ℓℓHigh : 67
Washing 1Hour Spinning 15minutes
2
ℓℓ
DC68-01288A
Loading...