Samsung WT90C1, WT12S2, WT11S2, WT10S2P, WT10S2 User Manual
BEFORE USING THE WASHER
DESCRIPTION OF PARTS
▶ Remove the cap-hose from the drain
hose.
CAUTIONS
▶▶
Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
▶▶
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
▶▶
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
▶ In case of pump drained washer,
remove the cap-hose from
the drain hole.
▶▶
Disconnect the power cord from the
power supply when not in use.
▶▶
Ventilation
by carpeting when the washing machine is
installed on a carpeted floor.
▶▶
If the supply
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
▶▶
To
must be filled with the operator present using a
moderate water supply pressure only.
opening must not be obstructed
cord of this appliance is damaged,
avoid overfilling and damages this appliance
Otherwise,excessive vibration
CONTROL LEG
Adjust the control leg
and noise can occur
for even placement.
during spinning
Be sure to keep the lid
closed during washing
WASH TUB LID
and spinning.
during washing.
the dregs which are made
This is used for gathering
LINT FILTER
OVER FLOW
FILTER
SPIN DRYER LID
When you open this lid while
the spinning will be stopped
the spin basket is spinning,
by breake system.
PRECAUTIONS WHEN OPERATING
▶▶
Don't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
▶▶
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
▶▶
Close the water tap a little if the
water pressure is too high.
▶▶
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
▶▶
To avoid water splashes,
close the wash tub lid.
▶▶
Never splash water on the control panel.
1 2
PULSATOR
WATER DRAIN HOSE
(WITHOUT PUMP)
EARTH WIRE
(Option)
POWER CORD
The plug’s shape
may not correspond
with this drawing.
WASH TUB
SPIN DRYER HATCH
SPIN DRYER BASKET
DRAIN HOSE
(with pump)
INNER LID
1 2 3 4 5
CONTROL PANEL WASHING PROCEDURE
SWT90C1(P) / SWT90C2(P)
WT10S0(P) /WT10S1(P) /WT10S2(P)
11..
WATER
22..
WASH TIMER
33..
WASH
SW-903(P)
11..
WASH TIMER
22..
WASH CONTROL
33..
SPIN DRY TIMER
SELECTOR
During washing, WATER SELECTOR KNOB
should be selected to wash. During spin rinsing,
WATER SELECTOR KNOB should be selected to spin.
This is used to set the wash time, 1-15 minutes.
SELECTOR
You can wash laundry effectively by various methods.
(B)Type
This is used to set the wash time, 1-15 minutes.
You can wash laundry effectively by various methods.
This is used to set the spin time 1-5 minutes.
FRONT PANEL
(A)Type
44..
CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
55..
SPIN DRY TIMER
This is used to set the spin time 1-5 minutes.
44..
WATER INTAKE
Connect water inlet to a tap with a suitable.
DRAIN SELCTOR
55..
Be sure to press the selector knob to ‘WASH’ while washing.
TO WASH
Before starting washing, ; Connect the water supply hose and open the water tap.
check the following - Lay the drain hose down toward a sinkhole.(In case no drain pump)
(A)Type
1. Set the CYCLE SELECTOR KNOB to
‘‘
WASH••RINSE
2. Set the WATER SELECTOR
KNOB to WASH .
3. Select the
WASH SELECTOR KNOB
for desired mode.
4. Fill water in the wash
tub to the‘‘L1’’lower
water level by carefully
adjusting the tap water
and add the detergent.
5. Put the cloths into
the wash tub and
set the same water
pressure to fill the
tub so as not to
exceed ‘H3’level.
’’..
(in case drain pump “WASH”)
- Place the drain hose in sink or bath.(In case drain pump)
- Connect the power cord to the power supply outlet .
(B)Type
1. Select the WASH CONTROL KNOB
for desired mode.
2. Press the
DRAIN SELECTOR KNOB
to ‘WASH’ .
3. Fill water in the wash tub
to the‘‘L1’’lower water
level by carefully
adjusting the tap water
and add the detergent.
4. Put the cloths into the
wash tub and set the
same water pressure
to fill the tub so as not to
exceed ‘H3’level.
5. Set the WASH TIMER
1-15minutes.
REAR PANEL
3 4
6. Set the WASH TIMER
1-15minutes.
7. After washing, set the
CYCLE SELECTOR KNOB
to ‘DRAIN’’for drain.
6. After washing Press the
DRAIN SELECTOR KNOB to
‘DRAIN’ for drain .
Loading...