Vacuum
Cleaner
For Household
use Only
Operating
Instructions
Read these instructions before operating the vacuum cleaner
The design and specification may be different depending on the models.
Register your product at www.samsung.com/global/register
Safety Instructions
Thank you for purchasing a Samsung vacuum cleaner. When using an electrical appliance, basic precautions should always be followed, including the following:
PLEASE READ ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS APPLIANCE
Warning:
. Unplug the vacuum from the outlet
necessary when used by or near
manufacturer’s recommended
is not working as it should, or has water, take it to a service center. the cord as a handle. Do not close a corners. Do not run the appliance
.
unplug, grasp the plug, not the
operate with any opening blocked: air flow.
away from openings and moving
such as cigarettes, matches
such as gasoline. Do not use
.
outlet with inadequate current
disconnecting the hose, replacing
.
.
Save these instructions!
has a polarized plug with one blade only one way. If the plug does fit, contact a qualified electrician to
.
1
Assembling Parts
to the left.
|
Handle |
|
|
Power Switch |
|
|
Upper Tank |
|
|
Frame and |
|
Louvers |
Filter(Inside |
|
|
Louvers) |
|
Cord |
Upper Tank |
|
Container |
Post-Motor Filter |
|
Filter |
Hepa Media Filter |
|
Height |
(Optional Item) |
|
Lock ’n Seal™ |
||
Adjustment |
||
Lever |
||
Knob |
||
Handle |
||
Powerfoot |
||
Release Pedal |
||
|
Furniture Protection Guard |
VOLTAGE SPECIFIED ON THE NAMEPLATE.
1-2 |
the |
to |
. |
firmly |
the |
body. |
Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the Handle is flush.
Insert one screw provided from the screw packet into the existing hole. Tighten securely with a Philliphs head screwdriver.
1-4
Assembly on the back of the vacuum as shown.
Attach the Hose with the remaining two screws from the packet. Tighten securely with a screwdriver.
Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Snap the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively unless the Hose Wand is firmly attached.
1-5 |
Slide the |
|
Extension |
|
Wand and |
|
the Crevice |
|
Tool together |
|
into the |
|
storage clip |
|
as shown. |
Slide the Dusting Brush Tool into the storage clip as shown.
2