Samsung VC-9800, SW7260 User Manual

Operating Instructions
Samsung Smart Drum Vacuum Cleaner
Before operating this unit, please read the instructions carefully.
Indoor use only.
Register your product at www.samsung.com/global/register

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following :
1. Read all instructions before using this vacuum cleaner.
2. This machine is suitable FOR INDOOR USE ONLY.
3. Before using the vacuum cleaner, make sure that the voltage shown on the rating plate on the side of the machine corresponds with the mains voltage.
4. If this machine is not correctly operating with any problem such as strange noise, smell or smoke from it, switch it off and consult the authorized service agent.
5. Keep the machine away from heat sources which can make the plastic parts of the unit deform and discolor.
6. Do not spray flammable or combustible liquids such as gasoline on the cleaner.
7. Do not step and put a weight on the cord and hose.
8. The use of an extension cord is not recommended and don't put plug in the electrical outlet
working with other electric appliances.
9. This machine must not be used without the bucket and filter. empty the bucket before it is full
in order to maintain the best efficiency.
10. Overheating can be caused by blockage in the filter, nozzle, tube or hose. After removing
the cause and cooling the motor, vacuum cleaner automatically start again.
11. Do not connect plug when not in use.

WARNING

1. Remove water or dust on plug with dry towel, also don't handle plug and this machine with
wet hands.
2. Turn machine off before unplugging.Do not unplug by pulling on cord.
3. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
4. This machine must not be used if there are harmful gases in the house. Let the house ventilated.
5. This machine must not be used as a toy or chair.
6. The tube must not be used for other purpose except cleaning dust or vacuuming water and
also don't block suction and exhaust part, including tube.
7. The appliance is not intended for use by young persons or infirm persons without supervision.
8. The plug must be removed from the socket outlet before cleaning or maintaining the
appliance.
9. This machine must not be used for picking up hard, sharp, explosive materials and a bubbly
detergent.
10. This appliance is not intended for use by young persons or infirm persons without supervi-
sion unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely.
11. Young children should be supervised to ensure that they do not play with the appliance.

ASSEMBLING PARTS

1
IDENTIFICATIONS OF PARTS
HOSE HANDLE
COVER DUST
SUCTION HOSE
DUST-FULL INDICATOR
EXTENSION
CONTROL BUTTON
TUBE
ON/OFF SWITCH
FLOOR NOZZLE
CASTER
ATTACHMENTS
HANDLE
CLAMPER DUST
COVER
ATTACHMENT
BUCKET
HOLDER HANGER
TUBE
FLOOR NOZZLE
DUSTING BRUSH
SUCTION HOSE
CREVICE TOOL WATER BRUSH
FLOOR BRUSH

ASSEMBLING THE VACUUM CLEANER

2
1) Attaching the Suction Hose to the Cleaner
Slide the Suction Hose Clamper to the Suction Inlet of the Cleaner and Turn it clockwise until it "clicks" into place.
2) Attaching the Tube to the Suction Hose
Slide the narrow end of the Suction Hose section into the end of the tube.
3) Attaching the Floor Nozzle
Slide deeply the free end of the Tube into the Floor Nozzle.
ASSEMBLING ACCESSORIES
When attaching to the Suction Hose
When using the Tube
When attaching to the Tube
Extending
Holding the narrow side of the tube with a hand, pull the handle to the opposite side of it with another hand.
Shortening
Push the handle to the narrow side of the tube, holding it with another hand.

OPERATION

3
ON/OFF SWITCH
Press down "I" button at the top left side of the Body.
After cleaning, Press down "O" button at the top left side of the Body.
POWER CORD
PULLING OUT
The long power cord can be drawn out for your convenience.
NOTE
When removing the power cord from the electrical outlet,grasp the plug,not the cord.
REWINDING
After disconnecting the plug from the electrical outlet,press the cord rewind button lightly with your toe.The cord will automatically rewind.
BRUSHES
FLOOR NOZZLE
Using on Carpet Using on Tile or Floor
DUSTING BRUSH CREVICE TOOL
Dusting brush for furniture, shelves, books, etc.
Crevice tool for radiators, crevices, corners, between cushions.
For efficiency, clean Floor Nozzle with Crevice Tool.
BUCKET AND FILTER
Caution :
134
Turn the Suction Hose Clamper counterclockwise and pull it out.
disconnect Plug before discarding dusty materials
2
Open the Cover Dust.
Hold the Bucket Handle and pull the bucket out.
Detach Filter. Dispose dusty
5
materials.
After using,if the filter is full of dust,clean it as picture and use it again.

TOOL STORAGE

4
PARK POSITION
For easy storage,this vacuum cleaner has a hanger system built on the body, which will keep the Tube, Suction Hose and Floor Nozzle in a vertical position.
HANGER
ACCESSORIES

SAFETY EQUIPMENT

5
FLOAT
HOLDER HANGER
Pull the Cover Attachment downward for using Accessory Tools and keep Crevice Tool and Dusting Brush as pictures.
FLOAT
Float works when there are too much dusty materi­als including water in order to prevent overflow to Motor Suction Part.
When Float works on malfunction, Take a break 10 minutes and go on.
Suction Power will be lowered when Float works but Motor go on, therefore turn Switch off and discard dusty materials.
THERMAL CUT-OUT PROTECTION
The vacuum cleaner is provided with a self-resetting thermal cut-out protection which automatically shut off current on over heating.Overheating can be caused by blockage in the filter, nozzle, tube or hose.After removing the cause and cooling the motor,vacuum cleaner automatically start again.

TROUBLESHOOTING

6
- IF YOU HAVE A PROBLEM
PROBLEM CAUSE REMEDY
Cleaner doesn’t run.
Poor job of dirt pickup.
Cord doesn't rewind fully
Motor runs but doesn't suck up water.
Cover dust comes out.
Not firmly plugged in.
Clogged hose or filter, tube, nozzle.
Check that the cord is not twisted or wound unevenly.
Check the float in suction.
Doesn't break down.
Plug unit in firmly.
Remove the object.
Pull the cord out 2~3m and push down the cord rewind button.
Discard the water in the bucket.
Insert it in the cleaner.
If you have any comments or questions regarding a Samsung products, contact the SAMSUNG customer care center.
Country
AUSTRALIA
HONG KONG
MALAYSIA
SINGAPORE
Customer Care Center
1300 362 603
2862 6001
1800-88-9999
1800-SAMSUNG (7267864)
Web Site
www.samsung.com/au
www.samsung.com/hk
www.samsung.com/my
www.samsung.com/sg
DJ68-00260A REV(0.3)
Loading...