Samsung VC-9630 User Manual
Operating Instructions
VACUUM CLEANER
❈ Before operating this unit, please read the instructions carefully.
❈ For indoor use only.
Register your product at www.samsung.com/register
DJ68-00329H REV(0.4)
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
4. Do not use the vacuum cleaner without a dust bag. Replace the dust bag before it is
full in order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep
the vacuum cleaner away from stoves and other heat sources.
Heat can deform and discolour the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner parts. Do not stand on the hose assembly. Do not put a weight on the hose.
Do not block the suction or the exhaustion part.
7. Switch the vacuum cleaner off at the machine before unplugging from the electrical
outlet. Do not pull on the cord to disconnect the plug from the electrical outlet. Ensure
that it is disconnected before attending to the filter.
8. The plug must be removed from the socket out-let before cleaning or maintaining the
appliance.
9. The use of an extension cord is not recommended.
10. If your vacuum cleaner is not operating correctly, switch off the power supply and
consult an authorized service agent.
11. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
12. The vacuum cleaner is provided with a self-resetting thermal cut-out which automati-
cally shuts off on over-heating. Overheating can be caused by blockage in the filter,
nozzle, tube or hose. After removing the cause and allowing the motor to cool, the
vacuum cleaner will automatically restart.
2
ASSEMBLING THE CLEANER
1
OPTION
OPTION
Features may vary according to model.
▼
For storage, park the floor nozzle.
3
OPERATING THE CLEANER
2
2-1 POWER CORD
NOTE
When removing
the plug from the
electrical outlet, grasp
the plug, not the cord.
2-3 UV STERILIZATION LAMP(OPTIONAL)
The UV light is effective to kill bacteria in the dust chamber's filter, and when pushed the "ON/OFF" switch button, the UV lamp
is turned on automatically and keeps performing the bacteria
killing operation as long as the light remains on.
Besides,although it is stopped when the UV lamp is turned on it
continues killing bacteria in the dust chamber's filter.
2-2 ON/OFF SWITCH
UV STERILIZATION LAMP
NOTE : Do not stare for a long time the UV STERILIZATION LAMP directly as
can be harmful in eyes.
2-4 AIR CONTROL
To reduce suction for cleaning draperies, small rugs, and other
light fabrics, pull the tap air until the hole is open.
4
2-5 POWER CONTROL
1) BODY-CONTROL TYPE
MIN = For delicate surface e.g. net curtains.
MAX = For hard floors and heavily soiled carpets.
2) REMOTE-CONTROL TYPE (INFRARED-CONTROL)
SENDER
HANDLE CONTROL
SENDER
CONTROL
BUTTON
Press Power Control button
repeatedly to select correct mode.
(STOP → MIN → MID → MAX→ STOP)
NOTE :
1.
When using the control button for suction power,make sure that the transmitter of the
remote controller not be blocked by your body.
2.
When operating the cleaner in a room with a high ceiling or under intensive light, the
suction power controlling button may not work properly.So,use the “Power Control”
button on the main body
3. When the battely is run down, it does not work with the button pressed on the handle control part. In this case, replace the battery.(How to change: Refer to User Manual No5.)
AUTO MODE (OPTIONAL)
1. If pressing the "AUTO BUTTON" of the handle, "AUTO-LAMP"of the main body turns on
and operates.
2. AUTO-MODE adjusts absorption power
depending on increase or decrease of sucked
dusts to maintain optimum cleaning status.
3. The "Power +/-button"can adjust power to
MIN/MID/ MAX.
RECEIVER
5
2-6 USING FLOOR TOOLS
Carpets
CREVICE
Bare floors
OPTION
Blanket brush Bedclothes or Blanket
DUSTING
UPHOLSTERY
OPTION
Cut off pet hairs or threads sur-
rounding brush by using scissors.
6
Loading...