Samsung VC-6014 User Manual [hu]
Operating Instructions
VACUUM CLEANER
❈ Before operating this unit, please read the instructions carefully.
IMPORTANT SAFEGUARDS
▲
This appliance must be connected to the same main voltage as
shown on the rating plate.
▲
This vacuum cleaner is not suitable for removing any kind of liquid.
▲
Carpets treated with a liquid cleaner must be allowed to dry before
being cleaned with the unit.
▲
Never operate the vacuum cleaner without a dust bag.
▲
The cover cannot be closed if a dust bag is inserted. Please do not
close forcibly.
▲
Keep children away from this vacuum cleaner. It must not be used
on people or animals.
▲
Never use your appliance to vacuum matches, glowing embers, or
cigarette-ends. Avoid vacuuming hard, pointed objects, since they
may damage the appliance or dust bag.
▲▲
If your vacuum cleaner has a fault, please contact your electrical
retailer or an auth-orized service agent.
If the main cable is defective, the complete cable winder must be
replaced by a service agent.
PROTECTING THE ENVIRONMENT
▲
Once you have unpacked the unit, do not simply throw the packing
into the household waste.
▲
Take them to the appropriate collecting points for recycling.
EN-1
HANDLE
AIR REGULATOR
IDENTIFICATIONS OF PARTS
SUCTION HOSE
TUBE*
BUTTON FOR SUCTION
HOSE REMOVAL
CARRYING
HANDLE
FLOOR NOZZLE*
▲
Features marked with *may vary according to model.
RUG/FLOOR
SELECTOR
ASSEMBLING THE VACUUM - CLEANER READY FOR USE
1) Connect the suction hose to the
suction tube.
3) Connect the nozzle to the suction
tube.
4) Connect the body connector to the body
of the cleaner.
2) Connect the suction tubes together
(depending on model).
OPTION : Adjusting the telescopic
DUST-FULLINDICAT OR
CORD REWIND BUTTON
POWER CONTROL SWITCH*
ON/OFF BUTTON
CLAMPER FOR DUST BAG
COMPARTMENT
tube(depending on model).
EN-2
POWER CORD
1) PULLING OUT
The power cord is long enough to
be drawn out for convenience.
2) REWINDING
When you have finished cleaning,
disconnect the plug from the
electrical outlet and simply press
the cord rewind button lightly with
your toe.
NOTE :
When removing the power cord from the electrical outlet, grasp
the plug, not the cord.
ON / OFF SWITCH
With the cord plugged into an
electrical outlet, start or stop the
vacuum cleaner by pushing lightly
downward on the switch with your
toe.
POWER CONTROL(VARIABLE CONTROL TYPE ONLY )
The vacuuming power can be
adjusted to suit any situation with the
electrical power control.
MIN = For delicate fabrics, e.g.net
curtains.
MAX = For hard floors and heavily
soiled carpets.
EN-3
DUST-FULL INDICAT OR
If the “Dust-Full” indicator changes to “RED” while you are cleaning, the
dust bag requires replacement.
NOTE :
If the “Dust-Full” indicator continues to display “RED” even after
changing the dust bag, turn the cleaner off and check whether the
hose, tube or nozzle is clogged.
USING THE ACCESSORIES
CREVICE DUSTING
•
Crevice tool for
radiators, crevice,
corners, between
cushions.
•
Dusting brush for
furniture, shelves,
books, etc.
•
Before use, assemble
the dusting brush to
the crevice tool.
TOOL STORAGE
Your cleaner features a tool storage
device.
Assemble the accessory hanger on to the
extension tube. It can be used to store the
cleaning tools while they are not in use.
This tool can be separated into two parts.
Located on the left rear side of the
cleaner.
1) Disconnect the hose from the body
of the cleaner.
2) Connect the hose clamper to the
blow hole.
EN-4
USING THE BLOWER
PARK POSITION
Located in the top rear side of the
vacuum-cleaner, there is a nozzle
support that can be used to park
the nozzle during pauses in
cleaning.
TRANSPORTING AND STORING THE VACUUM CLEANER
For easy storage and
transportation, this vacuum cleaner
has a clip system built onto the
body, which will keep the tube,
hose and nozzle in a vertical
position.
REPLACING THE DUST BAG
1) To open the dust cover of the
dust bagcompartment, press
the clamper upward.
(The clamper is located at the
front of the dust cover)
2) Remove the carrying bag from
the cleaner.
EN-5
Loading...