Samsung VC-6015V, VC-6014V, VC-6014, VC-6013V, VC-6012 User Manual [en, nl, fr, de]
VC-6000-EN 4/24/01 9:05 AM Page 3
GB
Operating Instructions
NL
Gebruiksaanwijzing
F
Mode d’emploi
VC-6000 SERIES
VACUUM CLEANER
❈ Before operating this unit, please read the instructions carefully.
VC-6000-EN 4/24/01 9:05 AM Page 4
IMPORTANT SAFEGUARDS
◗ This appliance must be connected to the same main voltage as shown on the rat-
ing plate.
◗ This vacuum cleaner is not suitable for removing any kind of liquid.
◗ Carpets treated with a liquid cleaner must be allowed to dry before being cleaned
with the unit.
◗ Never operate the vacuum cleaner without a dust bag.
◗ The cover cannot be closed if a dust bag is inserted. Please do not close forcibly.
◗ Keep children away from this vacuum cleaner. It must not be used on people or
animals.
◗ Never use your appliance to vacuum matches, glowing embers, or cigarette-
ends. Avoid vacuuming hard, pointed objects, since they may damage the appliance or dust bag.
◗ If your vacuum cleaner has a fault, please contact your electrical retailer or an
auth-orized service agent.
◗ If the main cable is defective, the complete cable winder must be replaced by a
service agent.
PROTECTING THE ENVIRONMENT
◗ Once you have unpacked the unit, do not simply throw the packing into the
household waste.
◗ Take them to the appropriate collecting points for recycling.
GB-1
VC-6000-EN 4/24/01 9:05 AM Page 5
I D E N T I F I C ATIONS OF PA RT S
HANDLE
AIR REGULATOR
TUBE*
BUTTON FOR SUCTION
HOSE REMOVAL
CARRYING HANDLE
FLOOR NOZZLE*
◗ Features marked with *may vary according to model.
RUG/FLOOR SELECTOR
ASSEMBLING THE VACUUM - CLEANER READY FOR USE
1) Connect the suction hose to the suction
t u b e .
3) Connect the nozzle to the suction tube.
2) Connect the suction tubes together
SUCTION HOSE
DUST-FULL INDICATOR
CORD REWIND BUTTON
POWER CONTROL
SWITCH*
ON/OFF BUTTON
CLAMPER FOR DUST BAG
COMPARTMENT
(depending on model).
4) Connect the body connector to the body
of the cleaner.
GB-2
OPTION : Adjusting the telescopic
tube(depending on model).
VC-6000-EN 4/24/01 9:05 AM Page 6
POWER CORD
1) PULLING OUT
The power cord is long enough to be
drawn out for convenience.
2) REWINDING
When you have finished cleaning, disconnect the plug from the electrical
outlet and simply press the cord
rewind button lightly with your toe.
NOTE :
When removing the power cord from the electrical outlet, grasp the plug,
not the cord.
ON / OFF SWITCH
With the cord plugged into an electrical
outlet, start or stop the vacuum cleaner
by pushing lightly downward on the
switch with your toe.
POWER CONTROL(VARIABLE CONTROL TYPE ONLY )
The vacuuming power can be adjusted
to suit any situation with the electrical
power control.
M I N = For delicate fabrics, e.g.net cur-
tains.
MAX = For hard floors and heavily
soiled carpets.
GB-3
VC-6000-EN 4/24/01 9:05 AM Page 7
D U S T-FULL INDICATO R
If the “Dust-Full” indicator changes to “RED” while you are cleaning, the dust bag
requires replacement.
NOTE :
If the “Dust-Full” indicator continues to display “RED” even after
changing the dust bag, turn the cleaner off and check whether
the hose, tube or nozzle is clogged.
USING THE ACCESSORIES
CREVICE DUSTING
Crevice tool for radiators,
crevice, corners, between
cushions.
Your cleaner features a tool storage
device.
Assemble the accessory hanger on to the
extension tube. It can be used to store the
cleaning tools while they are not in use.
This tool can be separated into two parts.
Located on the left rear side of the
cleaner.
1) Disconnect the hose from the body of the
cleaner.
2) Connect the hose clamper to the blow
hole.
Dusting brush for furniture, shelves, books, etc.
GB-4
Before use, assemble the
dusting brush to the
crevice tool.
TOOL STO R A G E
USING THE BLOWER
VC-6000-EN 4/24/01 9:05 AM Page 8
PARK POSITION
Located in the top rear side of the
vacuum-cleaner, there is a nozzle support
that can be used to park the nozzle during
pauses in cleaning.
T R A N S P O RTING AND STORING THE VACUUM CLEANER
For easy storage and transportation, this
vacuum cleaner has a clip system built
onto the body, which will keep the tube,
hose and nozzle in a vertical position.
REPLACING THE DUST BAG
1) To open the dust cover of the dust
bagcompartment, press the clamper
upward.
(The clamper is located at the front of
the dust cover)
2) Remove the carrying bag from the
cleaner.
GB-5
VC-6000-EN 4/24/01 9:05 AM Page 9
3) After removing the used dust bag,
insert the cardboard bag collar of the
new dust bag into the carrying bag.
NOTE :
Used dust bag can be sealed by
removing the film from the paper
and sticking the latter over the
suction opening.
(ONLY PAPER BAG)
4) Press the dust cover down gently
until the clamper relocks.
FOR CLOTH FILTER BAG
After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again.
MAINTENANCE OR REPLACEMENT OF THE FILT E R S
1) INLET-FILTER.
• Open the dust cover.
• After detaching the filter, wash it lightly withwater, dry it in the shade, and then insert it in
its original position.
•Close the dust cover.
2) OUTLET-FILTER.
•To open the filter cover, press front and pull it
simultaneously.
•Remove and replace the dirty microfilter.
•Close the cover.
GB-6
VC-6000-EN 4/24/01 9:05 AM Page 10
USAGE OF FLOOR NOZZLE
FOR RUG / FLOOR SELECTOR
Before use make sure that the position of the selector is in the right position for the
type of surface to be cleaned.
Select the carpet indicator when cleaning carpets..
Select flat surface indicator when cleaning the floors, tiles, etc.
FOR UNIVERSAL BRUSH
Use the floor nozzle for all cleaning surfaces.
NOTE :
For optimum efficiency, clean floor brush with crevice tool.
TROUBLE SHOOTING
P R O B L E M C A U S E R E M E D Y
Motor does not start. No power supply. Check cable, plug and
Suction force is gradually Filter, nozzle, suction hose Remove the object.
decreasing. or tube is blocked.
Cord does not rewind fully. Check that the cord is not Pull the cord out 2~3m &
twisted or wound unevenly. push down the cord rewind
socket.
b u t t o n .
GB-7
Loading...