Samsung UN55HU7250FXZA, UN55HU7200FXZA Installation Guide
1
Unpack
Taking the TV Out of the Box
• Warning:
Do not touch the TV’s
screen when you take
it out of the box. Hold it
by its edges only. If you
touch the screen, you
can cause the TV panel
to crack.
Included in this Box
Remote Control
MIC
TV
KEYPAD
SEARCH
SOURCE
CH
VOL
VOICE
GUIDE
RETURN
CH.LIST
EXIT
SMART HUB
3D CC P.SIZEMTS
INFO
MENU
Samsung Smart
Control
Also included
• User manual
• Regulatory guide
Batteries
• Recommendation 1:
Two people should
remove the TV from the
box as shown above.
When removing the
TV, hold it by its edges
only. Do not touch the
screen.
Stand Parts and Cables
(2 AA)
• Recommendation 2:
If only one person is
available to remove
the TV from the box,
remove it as shown in
the illustration above.
Hold the TV by its
edges. Do not touch
the screen.
Base &
Screws (x4)
Power Cord IR Extender Cable
Wall Mount
Adapter (x4)
Stand Mount &
Screws (x4)
[HU7200-QSG]BN68-06543A-01ENG.indb 1 2014-09-30 1:27:18
2
Warning
Do not remove the Styrofoam on the front
of TV screen.
X 4 (M4 X L12)
Assemble
X 4 (M4 X L14)
1 Locate the Base, Stand Mount, and
Screws in the box and set them
aside.
Remove the top portion of the
✎
box to locate the stand parts.
3 Lay the TV on a soft surface, screen
side down. Use the Styrofoam to
protect the screen.
[HU7200-QSG]BN68-06543A-01ENG.indb 2 2014-09-30 1:27:20
2 With another person, hold the TV
by its edges, and then remove it
completely from the box.
4 As shown in the diagram, attach the
Stand Mount to the Base.
x4 (M4 X L14)
6-26-1
5 Insert 4 screws, and then use a
screwdriver to secure the Base to the
Stand Mount.
x4 (M4 X L12)
7 Insert 4 screws, and then use a
screwdriver to secure the stand to
the TV.
To assemble the wall mount, use
✎
the styrofoam that came with
the TV’s packaging to protect it.
Lay the TV down and attach the
screws.
[HU7200-QSG]BN68-06543A-01ENG.indb 3 2014-09-30 1:27:22
6 Holding the stand parallel to the
screen, slide the Mount into the
notches on the back of the TV.
8 After attaching the stand, set the
TV upright, and then remove the
Styrofoam from the front of the TV.
Do not place the TV at the edge
of any piece of furniture (table,
entertainment center, etc.). It could
fall and break or cause personal
injury.
3
Connect
* Recommended Connections
Connection panel on
the back of the TV
TV signal
Connect your
coaxial cable to the
Antenna In port.
After you have connected all
your external devices, plug the
TV’s power cord into the back
of the TV. DO NOT plug it into
a wall outlet until you have
reached Section 7, Initial Setup.
Cable/Satellite/DVR
Connect your Cable box or digital
video recorder with an HDMI cable.
Internet
Connect here with an Ethernet
cable or wirelessly later during
the Initial Setup.
[HU7200-QSG]BN68-06543A-01ENG.indb 4 2014-09-30 1:27:23
Loading...