Samsung UN55D6400, UN46D6450, UN46D6400, UN40D6450, UN55D6450 User Manual

...

E-MANUAL

Contact SAMSUNG WORLDWIDE

If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care center.

Country Customer Care Center Web Site Address

CANADA 1-800-SAMSUNG (726-7864) www.samsung.com Samsung Electronics Canada Inc., Customer

Service 55 Standish Court Mississauga, Ontario L5R 4B2 Canada

U.S.A 1-800-SAMSUNG (726-7864) www.samsung.com Samsung Electronics America, Inc. 85 Challenger

Road Ridgeﬁ eld Park, NJ 07660-2112

LED TV

user manual

imagine the possibilities

Thank you for purchasing this Samsung product. To receive more complete service, please register your product at

www.samsung.com/register

Model _____________ Serial No. _____________

BN68-03525A-00

Figures and illustrations in this User Manual are provided for reference only and may differ from actual product appearance. Product design and speciﬁcations may be changed without notice.

Important Warranty Information Regarding Television Format Viewing

✎

See the warranty card for more information on warranty terms.

Wide screen format LED Displays (16:9, the aspect ratio of the screen width to height) are primarily designed to view wide screen format full-motion video. The images displayed on them should primarily be in the wide screen 16:9 ratio format, or expanded to ﬁll the screen if your model offers this feature and the images are constantly moving. Displaying stationary graphics and images on screen, such as the dark sidebars on non-expanded standard format television video and programming, should be limited to no more than 5% of the total television viewing per week.

Additionally, viewing other stationary images and text such as stock market reports, video game displays, station logos, web sites or computer graphics and patterns, should be limited as described above for all televisions. Displaying stationary images that exceed the above guidelines can cause uneven aging of LED Displays that leave subtle, but permanent burned-in ghost images in the LED picture. To avoid this, vary the programming and images, and primarily display full screen moving images, not stationary patterns or dark bars. On LED models that offer picture sizing features, use these controls to view different formats as a full screen picture.

Be careful about the television formats you select and the length of time you view them. Uneven LED aging as a result of format selection and use, as well as burned in images, are not covered by your Samsung limited warranty.

y SAMSUNG ELECTRONICS NORTH AMERICAN LIMITED WARRANTY STATEMENT

Subject to the requirements, conditions, exclusions and limitations of the original Limited Warranty supplied with Samsung Electronics (SAMSUNG) products, and the requirements, conditions, exclusions and limitations contained herein, SAMSUNG will additionally provide Warranty Repair Service in the United States on SAMSUNG products purchased in Canada, and in Canada on SAMSUNG products purchased in the United States, for the warranty period originally speciﬁed, and to the Original Purchaser only.

The above described warranty repairs must be performed by a SAMSUNG Authorized Service Center. Along with this Statement, the Original Limited Warranty Statement and a dated Bill of Sale as Proof of Purchase must be presented to the Service Center. Transportation to and from the Service Center is the responsibility of the purchaser. Conditions covered are limited only to manufacturing defects in material or workmanship, and only those encountered in normal use of the product.

Excluded, but not limited to, are any originally speciﬁed provisions for, in-home or on-site services, minimum or maximum repair times, exchanges or replacements, accessories, options, upgrades, or consumables.

For the location of a SAMSUNG Authorized Service Center, please call toll-free: – In the United States : 1-800-SAMSUNG (1-800-726-7864) – In Canada : 1-800-SAMSUNG

Still image warning

Avoid displaying still images (such as jpeg picture ﬁles), still image elements (such as TV channel logos, stock or news bars at the screen bottom etc.), or programs in panorama or 4:3 image format on the screen. Constantly displaying still pictures can cause image burn-in on the LED screen, which will affect image quality. To reduce risk of this effect, please follow the recommendations below:

y Avoid displaying the same TV channel for long periods. y Always try to display any image in full screen. Use the TV set’s picture format menu for the best possible match. y Reduce brightness and contrast to avoid the appearance of after-images. y Use all TV features designed to reduce image retention and screen burn. Refer to the e-Manual for details.

English - 2

Accessories

✎

Please make sure the following items are included with your T V. If any items are missing, contact your dealer.

✎

The items’ colors and shapes may vary depending on the model.

✎

Check that there are no accessories hidden behind or under packing materials when you open the box.

y Remote Control (AA59-00442A) & Batteries (AAA x 2) y Owner’s Instructions

AV/Component Adapter AV Adapter Holder-Ring (4EA) Holder-Wire stand

(BN39-01154W) (BN39-01154H) (BN61-07295A) (BN61-05491A)

3D Active Glasses

(LED 6450 Series Only)

(BN96-18927A)

Input Cables (Sold Separately)

To purchase the RS232 cable, contact www.SamsungParts.com.

y Power Cord y Cleaning Cloth y Warranty Card / Safety Guide

RS232 (AA39-00311A) Audio

HDMI HDMI-DVI Component Composite (AV) Coaxial (RF) VGA

QWERTY Remote (Sold Separately)

QWERTY Remote

English - 3

Viewing the Control Panel

✎

The product color and shape may vary depending on the model.

✎

There are control buttons in rear of T V. When you touch the button, control icons appears.

✎

Any object (an electric wire, etc.) near the control panel may cause unintended activation of the OSD.

TV Rear

Remote control sensor Aim the remote control towards this spot on the TV.

Power Indicator Blinks and turns off when the power is on and lights up in standby mode.

(Source)

MENU Displays an on-screen menu, the OSD (on screen display) of your TV’s features.

Toggles between all the available input sources. In the on-screen menu, use this button as you would use the ENTER

button on the remote control.

o (Volume)

k (Channel)

(Power)

Standby mode

Your TV enters Standby mode when you turn it off and continues to consume a small amount of electric power. To be safe and to decrease power consumption, do not leave your TV in standby mode for long periods of time (when you are away on a holiday, for example). It is best to unplug the power cord.

Adjusts the volume. In the OSD, use the ► buttons on the remote control.

Changes the channels. In the OSD, use the <> buttons as you would use the ▼ and ▲ buttons on the remote control.

Turns the TV on or off.

buttons as you would use the ◄ and

Install the Stand

See separate guide for installing the stand.

1 EA

Stand (1EA) Guide Stand (1EA) Screws (8EA)

1 EA

x4 (M4 X L12)

x4 (M4 X L8)

English - 4

Top View

(M4 X L12)

Front

Rear

Side View

ATTENTION

DO NOT USE

CHEMICALS

(Correct assembly)

GREASE

DO NOT USE

OIL

✎

Place a soft cloth over the table to protect the TV, and then place the TV on the cloth screen side down.

✎

Insert the Stand Guide into the slot of TV bottom side.

(Incorrect assembly)

(M4 X L8)

✎

NOTE

Make sure to distinguish between the front and back of each component when assembling them.

Make sure that at least two persons lift and move the TV.

Stand the product up and fasten the screws. If you fasten the screws with the TV placed down, it may lean to one

side.

Assembling the Holder-Wire stand

English - 5

Installing the Wall Mount

Preparing before installing Wall-Mount

To install a wall-mount from another manufacturer, use the Holder-Ring.

Installing the Wall Mount Kit

The wall mount kit (sold separately) allows you to mount the TV on the wall. For detailed information on installing the wall mount, see the instructions provided with the wall mount. Contact a technician for

assistance when installing the wall mount bracket. Samsung Electronics is not responsible for any damage to the product or injury to yourself or others if you elect to install the TV on your own.

Wall Mount Kit Speciﬁcations (VESA)

Install your wall mount on a solid wall perpendicular to the ﬂoor. Before attaching the wall mount to surfaces other than plaster board, please contact your nearest dealer for additional information. If you install the TV on a ceiling or slanted wall, it may fall and result in severe personal injury.

✎

NOTE

Standard dimensions for wall mount kits are shown in the table below.

Samsung wall mount kits contain, a detailed installation manual and all parts necessary for assembly are provided.

Do not use screws that do not comply with the VESA standard screw specifications.

Do not use screws that are longer than the standard length or do not comply with the VESA standard screw

specifications. Screws that are too long may cause damage to the inside of the TV set. For wall mounts that do not comply with the VESA standard screw specifications, the length of the screws may differ

depending on the wall mount specifications. Do not fasten the screws too firmly. This may damage the product or cause the product to fall, leading to personal

injury. Samsung is not liable for these kinds of accidents. Samsung is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used or

the consumer fails to follow the product installation instructions. Our 55” model do not comply with VESA Specifications. Therefore, you should use our dedicated wall mount kit for

this model. Do not mount the TV at more than a 15 degree tilt.

Always have two people mount the TV on a wall.

Product Family

LED-TV

TV size in

inches

32~40 200 X 200

60~65 600 X 400

Do not install your Wall Mount Kit while your TV is turned on. It may result in personal injury due to electric shock.

VESA screw hole

specs (A * B) in

millimeters

Standard Screw Quantity

M8 446~55 400 X 400

English - 6

Remote Control Buttons

✎

This remote control has Braille points on the Power, Channel, and Volume buttons and can be used by visually impaired persons.

Turns the TV on and off.

Displays and selects the available video

sources.

Gives direct access to channels.

Press to select additional digital channels

being broadcast by the same station. For

example, to select channel ‘54-3’, press

‘54’, then press ‘-’ and ‘3’.

Adjusts the volume.

Opens the OSD.

Link to various application services.

Quickly select frequently used functions.

Selects the on-screen menu items and changes the values seen on the menu.

Returns to the previous menu.

POWER

SOURCE

2 3

5 6

7 8 9

MUTE

VOL CH

CH LIST

HUB

SMART

ON/OFF

PRE-CH

Turns the remote control light on or off. When on, the buttons become illuminated for a moment when pressed. (Using the remote control with this button set to On will reduce the battery usage time.)

Returns to the previous channel.

Cuts off the sound temporarily.

Changes channels.

Displays channel lists on the screen.

Support to recommendation search word and search function.

Displays information on the TV screen.

Exits the menu.

Buttons used in the Channel and

SMART HUB menu, etc.

Use these buttons in SMART HUB and

Anynet+ (HDMI-CEC) modes.

Installing batteries (Battery size: AAA)

T V

SO CI AL

E-MANUAL

✎

English - 7

B C D

SOCIAL TV: Connect to Social TV

application.

MTS: Press to choose stereo, mono,

or Separate Audio Program (SAP broadcast). X: Turns the 3D image on or off.

CC: Displays digital subtitles. P.SIZE: Lets you choose the Picture

Size.

E-MANUAL: Displays the e-Manual.

NOTE

Use the remote control within 23 feet from the TV.

Bright light may affect the per formance of the remote control

Avoid using when near special fluorescent lights or neon signs. The color and shape may vary depending on the model.

How to Navigate Menus

PRE-CH

CH LIST

POWER

2 3

5 6

7 8 9

MUTE

VOL CH

ON/OFF

SOURCE

PRE-CH

CH LIST

WER

MUTE

VOL

SMART

ON/OFF

SOURCE

HUB

Before using the TV, follow the steps below to learn how to navigate the menu and select and adjust different functions.

HUB

1 MENU button: Displays the main on-screen menu. 2 ENTER

select an item. Conﬁrm the setting.

3 RETURN button: Returns to the previous menu. 4 EXIT button: Exits the on-screen menu.

SMART

B C D

/ Direction button: Move the cursor and

How to Operate the OSD (On Screen Display)

The access steps may differ depending on the selected menu.

MENU The main menu options appear on

▲ / ▼ Select an icon or option with the ▲

ENTER

▲ / ▼

◄ / ►

ENTER

EXIT

the screen:

Picture, Sound, Channel, Network, System, Support.

or ▼ button. Press ENTERE to access the

sub-menus. Select the desired submenu with

the ▲ or ▼ button. Adjust the value of an item with the

◄ or ► button. The adjustment in the OSD may differ depending on the selected menu.

Press ENTERE to conﬁrm the selection.

Press EXIT.

✎

For the best cable connections to this product, be sure to use cables with a maximum thickness of 0.55 inches (14mm.)

Maximum thickness - 0.55 inches (14mm)

Connecting the power cord and an antenna or cable connection

When the TV is initially powered on, basic settings proceed automatically.

VHF/UHF Antenna

Cable

ANT OUT

Antenna Cable (Not Supplied)

Power Input

English - 8

+ 17 hidden pages