VACUUM CLEANER
Operating
lnstructions
❈Before operating this unit, please read the instructructions carefully .
DJ68-40131G(0.3) 2002.9.28 1:19 PM 1
IMPORTANT SAFEGUARDS
●
When you have unpacked the unit, do not simply throw the
packaging into the household waste.
●
Take them to the appropriate collecting points for recycling.
Protecting the environment
This appliance must be connected to the same mains voltage only
as shown on the rating plate.
This vacuum cleaner is not suitable for removing liquids of any kind.
Carpets treated with a liquid cleaner must be allowed to dry before
being cleaned with the unit.
Never operate the vacuum cleaner without a paper dust bag.
If no paper dust bag is inserted, the cover cannot be closed. Please
do not close forcibly.
Keep children away from the electrical appliance. It must not be
used on people or animals.
Never use your appliance to vacuum matches, glowing embers, or
cigarette-ends.
Avoid vacuuming hard, pointed objects, since they may damage the
appliance or paper dust bag.
If your vacuum cleaner has a fault, please contact your electrical
retailer or an authorized service agent.
If the mains cable is defective, the complete cable winder must be
replaced by a service agent.
1
▼▼▼▼
▼▼
▼▼▼
DJ68-40131G(0.3) 2002.9.28 1:19 PM 2
IDENTIFICATIONS PARTS
DUST-FULL INDICATOR
If the “Dust-Full” indicator switches to “RED” while you are cleaning, the paper
dust bag requires replacement.
If the “Dust-Full” indicator continues to display “RED” even
after changing the paper dust bag turn the cleaner off and
check whether the hose, tube or nozzle is clogged.
NOTE :
TAP AIR
: To reduce suction for cleaning draperies, small rugs, and other
light fabrics, pull the tap air until the hole is open.
Features marked with *may vary according to model.
HANDLE
TAP AIR
TUBE *
CYCLONIC
FILTER *
FLOOR NOZZLE *
RUG/FLOOR
SELECTOR
SUCTION HOSE
BUTTON FOR SUCTION
HOSE REMOVAL
CORD REWIND BUTTON
POWER CONTROL
SWITCH *
ON/OFF
BUTTON
DUST-FULL INDICATOR
CARRYING HANDLE
CLAMPER FOR PAPER
DUST BAG COMPARTMENT
TOOL STORAGE COVER
MICROFILTER CASSETTE
MICRO FILTER
2
▼
▼
DJ68-40131G(0.3) 2002.9.28 1:19 PM 3
ASSEMBLING THE VACUUM-CLEANER READY FOR USE
1) Connect the suction hose to the
suction tube.
2)
Connect the suction tubes together
(depending on model).
3
①Assemble the CYCLONIC FILTER
with the handle and extension
wand(depending on model).
➁Ajusting the telescopic tubes
(depending on model)
EXTENDING : Holding narrow
side of the telescopic tube with a
hand, pull the handle to the
oppo-site side of it with another
hand.
SHORTENING : Push the
handle
to the narrow side
of the tube, hoding
it with another
hand.
*
OPTION :
3) Connect the nozzle to the
suction tube.
4) Connect the hose clamper to the body
of the cleaner.
POWER CORD
When removing the power cord from the electrical outlet, grasp the plug, not
the cord.
1.PULLING OUT
The power cord is long enough to be drawn
out for a convenience.
2. REWINDING
Upon finishing cleaning disconnect the plug
from the electrical outlet and just press the
cord rewind button lightly with your toe.
NOTE
:
*OPTION
①
*OPTION
➁
DJ68-40131G(0.3) 2002.9.28 1:19 PM 4
With the cord plugged into an electrical
outlet, start or stop the vacuum cleaner
by pushing lightly on the switch
downward with your toe.
DUSTING BRUSH
ON/OFF SWITCH
SLIDING REGULATOR FOOT CONTROLS
UPHOLSTERY BRUSH
CREVICE TOOL
4
POWER CONTROL
The vacuuming power can be adjusted to suit any situation with the electrical
power control.
USING THE ACCESSORIES
Pull the tool storage cover upward.
●
Dusting brush-for furniture, shelves,
books, etc.
●
Upholstery brush-for cushions and
drapery.
●
Crevice tool-for radiators, crevice,
corners, between cushions.
= For delicate fabrics, e.g.net curtains.
= Economy setting for light to normally soiled carpets.
= For hard floors and heavily soiled carpets.
MIN
ECO
MAX
Located in the top rear side of the vacuum
cleaner, there is a support for a
convenient park position during pauses
when using the nozzle.
PARK POSITION
DJ68-40131G(0.3) 2002.9.28 1:19 PM 5
MIN
MAX
MIN
ECO
MAX