Samsung TC240-2-8, TC190, TC240 User Manual

SyncMaster TC190, TC240

LCD MONITOR

quick start guide

1 Installing the Product

1-1 Package Contents

• Unpack the product and check if all of the following contents have been included.

• Store the packaging box in case you need to move the Product at a later stage.

Monitor

CONTENTS

Installation Manual Product Warranty User Manual Power Cord

OPTIONAL PARTS

Keyboard (USB) Mouse (USB) D-Sub Cable

1-2 Installing the Stand

Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.

Place a soft cloth over the table to protect the product and place the product onto the
cloth so that the front of the product is facing downwards.

Do not remove the stopper pin before installing the base.

Hold the main body of the product with your hand as shown by the figure.

Insert the stand base into the stand connection part in the direction shown in the figure.

Turn the connecting screw at the bottom of the stand fully so that it is completely fixed.

After the installation of the base, stand the monitor up as shown in the figure. Now you
can remove the stopper pin to adjust the stand.

- Caution

Avoid lifting the product holding only the stand.

Disassembly is in the reverse order of assembly.

1-3 Installing a Wall Mount

Before installation, disassemble the product according to the following steps.

Lift up the monitor stand to the maximum angle with your left hand, and remove the back
decoration cover with your right hand, as shown in the figure.

Remove the two screws(A).

Remove the stand arm in the direction shown in the figure.

This product provides a wall mount of 100 mm x 100 mm(200 mm x 100 mm) that complies with the VESA specifications.

100 mm x 100 mm 200 mm x 100 mm

A. Wall Mount Base

B. Wall Mount Kit (Optional)

1. Turn the product off and unplug the power cord from the wall outlet.

2. Place a soft cloth or cushion on a flat surface to protect the panel and place the product face down.

3. Separate the stand.

4. Align the groove of the Monitor's wall mount base with the groove in the wall mount ki and firmly fix the wall mount kit by

fastening the screws.

•If you use a screw that is longer than the standard specifications, the inside of the product may be damaged.

•For wall mounts that are not compatible with the standard VESA specifications, the length of the screw may differ depending
on the corresponding specifications.

•Do not use screws that are incompatible with the standard VESA specifications and do not assemble them using excessive
force.

This may result in damage to the product or injury due to the product falling. Samsung shall not be held liable for any damage

or injury.

•Samsung shall not be held liable for any damage to the product or injury caused by using a stand that is not compatible with
the specified specifications or due to an installation not performed by an authorized installation engineer.

•When installing the product using a wall mount, purchase a wall mount that provides at least 4 inches (10 cm) of space from
the wall.

•Samsung shall not be held liable for any problems caused by using a stand that is not compatible with the specified
specifications.

•Use a wall mount according to specifications of your country.

1-4 Connecting to your Network

The connecting part may differ depending on the product model.

Connect between the [LAN] port on the product and your network using a LAN cable.