Samsung SW75X1SP, SW70X1, SW70X2, SW70X2P, SW75X1S User Manual

...
B
e sure that the washer is grounded.
To avoid electrical shock, use metal pipe for the ground connection.But do not ground the washer with gas pipes or telephone lines because of the dangers of explosion or lightning strike.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
D
uring spinning, don't put your hand
in the spin basket.
Because the spin basket is rotating at high speed, rotating parts may injure your hand.
Never allow children to operate or play with the washer.
Disconnect the power cord from the power supply when not in use.
2
FUZZY CONTROL Fuzzy control operates with best washing course
by sensing the washload like artificial intelligence.
CLEAN WASH BY THE DOUBLE FALL Double fall,falling down from top of the tub,cleans
heavy dirt and dissolves detergent throughly with impact power.
POWER BUTTON
Press this button once to operate. Press once again to turn the washer off.
START/HOLD BUTTON
Use to pause and restart the operation. To change the washing procedure during operation, press this button to stop, and once again to restart after changing the procedure.
DELAY START BUTTON
Press this button when delay start washing is needed.
FUNCTION SELECT BUTTON
With every press of this button, the function changes;
WASH➝RINSE➝SPIN➝WASH&RINSE
RINSE&SPIN➝WASH&RINSE&SPIN➝WASH
COURSE SELECT BUTTON
With every press of this button, the washing course changes;
FUZZY ➝SOAK➝WOOL ➝SPEEDY
Put your laundry into the washer evenly.
Uneven laundry may cause noise or vibration.
D
on't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged. Also, clothing may be deformed or bleached.
B
efore washing, check all pockets.
If nails or pins remain in pockets,they may damage the washer or clothes.
Never splash water on the control panel.
If the power supply cord of this washer is damaged, it must be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required.
DESCRIPTION OF PARTS
FEATURES
SAFETY INSTRUCTIONS
LID
Be sure to keep the lid closed during washing
and spinning.
Lint will be collected in the lint filter during washing.
When the water pipe is metal, make sure to cover the end of the ground wire.
Adjust the length of the
legs when installing
the washer.
LINT FILTER
POWER CORD
“MAGIC HAND”
PULSATOR
WATER DRAIN HOSE
DRAIN-HOSE (PUMP)
DETERGENT BOX
RINSE CASE
SOUND ABSORPTION PANEL
GROUND LEAD
FRONT CONTROL
PANEL
DOUBLE FALL GUIDE
BLEACH INLET
ADJUSTABLE LEGS
WATER SUPPLY HOSE(HOT)
WATER SUPPLY HOSE (COLD)
WATER LEVEL SELECT BUTTON
According to the washload,select the
water level ;
HIGH➝MEDIUM➝LOW
EXTRA LOW➝HIGH
WATER SUPPLY SELECT BUTTON
As you press this button, the type of water
is selected as follows.
COLD➝ COLDHHOT➝ HOT➝ COLD
REMAINING TIME INDICATOR LIGHT
The indicator light shows the remaining time (in minutes) of each wash cycle. At the end of the cycle,the power automatically switches off.
FUNCTION INDICATOR LIGHT
The function in use indicator shows the current function as a flashing symbol. The light goes out at the end of the function.
FUZZY
1
ADOPTION OF THE MAGIC HAND The “Magic Hand” provides both the powerful washing
action needed to completely clean larger and heavier items and the gentle washing action for dedicate fabric. The “Magic Hand” significantly increases washing power and ensures tangle-free operation.
Stainless
SPIN BASKET
CONTROL PANEL
3
WASHING PROCEDURE
4. Close the lid.
Only high or medium water level is available. Cold water is selected.
Selects the best washing course automatically.
1. Before starting washing, check the following;
Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure to lay down the drain hose.(In case no drain pump)
2. Put the laundry into the washer and add
detergent,too.
Be careful not to overload. Use right detergent for the fabrics you are washing.
3. Press the POWER Button to"ON".
The remaining time indicator should show "- -"
The laundry is soaked in water so that the dirt can be eliminated completely.
Select this course when you have to go out or do something else.
4. Press the START/HOLD button.
Water level is selected automatically. Washing,rinsing, and spinning follow.
If you want to pause, press the START/HOLD button again.You can change the course when paused.
5. Close the lid.
ex)
High level
POWER
COURSE
START/HOLD
START/HOLD
ex)
High level
CAUTION . . .
POWER
POWER
START/HOLD
ex)
High level
START/HOLD
ex)
High level
COURSE
COURSE
1.Press the power button to "ON".
POWER
1.Press the power button to "ON".
3.Press the START/HOLD button.
Washing,rinsing, and spinning follow.
If you want to pause ,press the START/HOLD button again.You can change the course when paused.
-Do not use water above 30˚C for WOOL washing.
-Refer to the tag attached on the clothes for washing information.
-Fasten buttons and turn inside out before washing.
-Use the detergent indicated in the laundry.
-When the degree of dirt is extreme, soak the laundry in warm water for about 10 minutes before pressing the WOOL course button in order to enhance washing efficiency.
2.Press the course select button twice.
1. Press the power button to "ON".
2. Press the course select button once.
3. Press the START/HOLD button
Water level is selected automatically. Washing,rinsing, and spinning follow.
If you want to pause, press the START/HOLD button again.You can change the course when paused.
4. Close the lid.
FUZZY COURSE
WOOL COURSE
4
4. Close the lid.
3. Press the START/HOLD button
Water level is selected automatically. Washing, rinsing, and spinning follow.
If you want to pause, press the START/HOLD button again.You can change the course when paused.
FUNCTION FUNCTION BUTTON TIME
MANUAL FUNCTIONS
WASH ONLY
Press the POWER button. Press the FUNCTION SELECT button once. Press the START/HOLD button once. Washing goes on for 23 minutes.
When the FUNCTION button is pressed during washing, the wash time can be changed to between 3 and 25 minutes in duration.
SPIN ONLY
Press the FUNCTION button three times. Press the START/HOLD button once. Spin drying goes on for 9 minutes.
When the FUNCTION button is pressed during spinning, the spin time can be changed to from 5 to 11 minutes.
WASH AND RINSE AND SPIN
Press the FUNCTION button six times. Press the START/HOLD button once. Washing, rinsing and spinning follow.
When the FUNCTION button is pressed during working, the rinse times can be changed to between 1 and 5 times in duration.
RINSE AND SPIN
Press the FUNCTION button five times. Press the START/HOLD button once. Rinsing and spin drying follow.
When the FUNCTION button is pressed during working, the rinse times can be changed to between 1 and 5 times in duration.
WASH AND RINSE
Press the FUNCTION button four times. Press the START/HOLD button once.
Washing and rinsing go on for 43 minutes.
When the FUNCTION button is pressed during working, the rinse times can be changed to between 1 and 5 times in duration.
RINSE ONLY
Press the FUNCTION button twice. Press the START/HOLD button once. Rinsing goes on for 15 minutes.
When the FUNCTION button is pressed during rinsing, the rinse times can be changed to between 1 and 5 times in duration.
2. Press the course select button three times.
six times
five times
four times
three times
twice
once
SOAK COURSE
4. Close the lid.
DELAY START
START/HOLD
POWER
1. Press the power button to "ON".
2. Press the DELAY START button once.
You may change the delay start time with use the DEALY START button. (from 3 hours to 12 hours)
The washing finishes by the time you reserved.
3. Press the START/HOLD button and put
the proper amount of detergent into the detergent box.
DELA Y ST ART COURSE
Because washing is speedy, it is good for light or less stained laundry.
SPEEDY COURSE
ex)
3 hours
ex) high level
ex) high level
ex) high level
ex) high level
ex) high level
ex) high level
Loading...
+ 2 hidden pages