Samsung STHA325 Users Manual

HHeeaalltthh aanndd SSaaffeettyy IInnffoorrmmaattiioonnHHeeaalltthh aanndd SSaaffeettyy IInnffoorrmmaattiioonn

111

110

should not contain metallic components in its assembly.
The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure

For additional information concerning exposure to
radio frequency signals, see the following websites:

Federal Communications Commission (FCC) RF
Safety program (select “Information on Human
Exposure to RF Fields from Cellular and PCS Radio
Transmitters”):
http://www.fcc.gov/oet/rfsafety

Cellular Telecommunications Industry

Association (CTIA): http://www.wow-com.com
World Health Organization (WHO) International

Commission on Non-ionizing Radiation Protection
(select Qs & As):
http://www.who.int/emf

United Kingdom, National Radiological

Protection Board: http://www.nrpb.org.uk
U.S.Food and Drug Administration (FDA) Center

for Devices and Radiological Health:
http://www.fda.gov/cdrh/consumer/

Tests for SAR are conducted using standard
operating positions specified by the FCC with the
phone transmitting at its highest certified power
level in all tested frequency bands. Although the SAR
is determined at the highest certified power level,
the actual SAR level of the phone while operation
can be well below the maximum value. This is
because the phone is designed to operate at multiple
power levels so as to use only the power required to
reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power
output.

Before a phone model is available for sale to the
public, it must be tested and certified to the FCC that
it does not exceed the limit established by the
government-adopted requirement for safe exposure.
The tests are performed in positions and locations
(e.g., at the ear and worn on the body) as required by
the FCC for each model. (Body-worn measurements
differ among phone models, depending upon
available accessories and FCC requirements). While
there may be differences between the SAR levels of
various phones and at various positions, they all
meet the government requirement for safety
exposure.

This device was tested for typical body-worn operations with requirements, and should be avoided.
the back of the phone kept 1.5 cm. from the body. To maintain
compliance with FCC RF exposure requirements, use only belt­clips, holsters or similar accessories that maintain a 1.5 cm.
separation distance between the user's body and the back

requirements, and should be avoided.

of the phone. The use of belt-clips, holsters and similar accessories