The information below is provided by the supplier of the referenced device without independent verification by Dell
and is subject to the restrictions and disclaimers
Introduction
Setup
Using the CD-RW/DVD ROM Drive
Troubleshooting
Specifications
Drive Connectors
Regulatory
Trademarks used in this text: SAMSUNG is trademarks of SAMSUNG Electronics Co.,LTD.; Dell and the DELL
are trademarks of Dell Computer Corporation. Microsoft and Windows are registered trademarks of Microsoft
Corporation.
noted below.
Restrictions and Disclaimers
The information contained in this document, including all instructions, cautions, and regulatory approvals and
certifications, is provided by the supplier and has not been independently verified or tested by Dell. Dell cannot be
responsible for damage caused as a result of either following or failing to follow these instructions.
All statements or claims regarding the properties, capabilities, speeds or qualifications of the part referenced in this
document are made by the supplier and not by Dell. Dell specifically disclaims knowledge of the accuracy,
completeness or substantiation for any such statements. All questions or comments relating to such statements or
claims should be directed to the supplier.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-mined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Re-orient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.
Back to Contents Page
CD-DA
Introduction: SAMSUNG SN-308 CD-RW/DVD ROM Drive
User's Guide
Manufacturer model name and number • Drive speed • Bus interface • Types of disc formats supported •
Software support
Drive has capability of reading CD, DVD and writing CD-R and CD-RW media through the use of
Standard sofware required to operate traditional CD, CD-RW and DVD Drives.
Manufacturer model name and number
SAMSUNG SN-308
• Features • Configuration • Front View
Drive speed
Read :
DVD : 8X
CD-ROM : 24X
CD-RW : 8X
Write :
CD-R : 2X. 4X. 8X
CD-RW : 2X. 4X, 8X
Bus interface
ATAPI BUS(IDE)
Types of disc formats supported
DVD :
DVD-5 : single-sided, single -layer format (4.3 GB)
DVD-9 : single-sided, dual-layer format (~ 7.9 GB)
DVD-10 : double-sided, single-layer format (~ 8.7 GB)
DVD-18 : double-sided, dual-layer format (~ 15.9 GB)
DVD-R : V1.9
CD :
CD-ROM(Mode-1,2)
Front View
CD-ROM XA(Mode-2, Form-1,2)
Photo-CD(Single, Multi -Session)
VIDEO-CD ready
CD-I(FMV)
CD-Plus
CD Extra
CD-R(Read/Write)
CD-RW(Read/Write)
CD-TEXT
Software support
?
Easy CD Creator Ver 4.04d10 or higher
?
CLONE Ver 2.67 or higher
?
Winon CD Ver 3.7 or higher
?
Juggler Ver 3.0 or higher
Features
?
Disc loading mechanism
This drive uses motor solenoid mechanism.
?
3-way disc ejection
Eject button, Software and Emergency Eject Hole
Audio capability
Audio capability follows the industry standard CD-Audio format.
?
MPC3 compatibility
Compatible
Configuration
This CD-RW/DVD ROM drive should be used only in its current hardware and software configuration.
Back to Contents Page
1. LED
This indicator lights green while data is being read.
2. Eject button
3. Emergency Eject Hole
If the disc tray does not open when you press the Eject button, insert a small, metal rod(an unwound
paper clip for example) into this hole to eject the disc.
* This function should only be performed when the computer is powered OFF.
4. Disc Tray
The Disc Tray will be open a little when you press the Eject button. Then you should pull the Tray open
completely.
* When you place a disc in the tray, make sure that the label on the disc is facing upwards.
Please read all restrictions and disclaimers.
Back to Contents Page
RW/DVD ROM Drive User's
Back to Contents Page
Setup: SAMSUNG SN-308 CD Guide
Dell Installed Drives • Drives Purchased Separately as Customer Kits
Note: To help avoid possible damage to the system board, unplug the computer system and wait 15
to 20 seconds for the standby power to dissipate before adding or removing any components from the
system.
Dell Installed Drives
Dell performs the installation and setup on CD-RW/DVD ROM drives that are shipped as part of a system,
including loading the appropriate device drivers when the operating system is installed. The drive is ready for
use when you receive your system. No further installation or configuration is necessary.
Drives Purchased Separately as Customer Kits
Installing the Drive
?
Install and configure the drive according to the instructions provided in the Dell
documentation for your system.
Verify Drive Operation by playing an Audio CD
1. Insert an Audio CD into the CD Tray.
2. Press the CD Tray until the tray is closed completely.
3. Audio CD will start playing (If Audio CD does not start-up, see Troubleshooting section).
Note: If customer has an older version of the NT file called cdaudio.sys this older
version will not play audio CD's and in some cases won't even read data CD's such as
Kodak Photo CD's. In addition, if the customer has the "Autorun feature" turned off, the
drive will not automatically start playing the CD.
Please read all restrictions and disclaimers.
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.