Samsung SHC-721N, SHC-721P, SHC-721PH User Manual

SAMSUNG CCD CAMERA

SHC-721N/P/PH

P/No. : 6806-0393-01A

Printed in Korea

WDR COLOR CCD CAMERA with
DAY & NIGHT

INSTRUCTION MANUAL

•

SAMSUNG TECHWIN., LTD

Optics & Digital Imaging Division
145-3, Sangdaewon 1-Dong, Jungwon-Gu,
Sungnam, Kyungki-Do, Korea
462-121

TEL: [phone]~41
FAX: [phone]

www.samsungcctv.com

•

SAMSUNG OPTO-ELECTRONICS AMERICA, INC.

Closed Circuit Division
40 Seaview Drive, Secaucus N.J
07094, U.S.A

TEL: [phone]
FAX: [phone]

SALES NETWORK

About this manual

Before installing and using the camera, please read this manual carefully. Be sure to keep it handy for later reference.

This installation should be made by a qualified service person and

should conform to all local codes.

The lightning flash with an arrowhead symbol, within an equilateral triangle is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.

INFORMATION-This equipment has been tested and found to comply with
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference
at his own expense.

WARNING -Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.

CAUTION : To prevent electric shock and risk of fire hazards:

Do NOT use power sources other than that specified.
Do NOT expose this appliance to rain or moisture.

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

54

Features Warning

Wide Dynamic Range(WDR)

Fine Picture Condition Under Very
Low Illumination (Sense up)

1/3 high density CCD and digital
processor permit high quality pictures to
be captured in very low light condition.

SV-II DSP chip built-in SAMSUNG TECHWIN
allows the camera to find the best picture
conditions in any environment and
automatically gives a necessary light level
compensation, so you can always obtain
the clear picture, the finest detail and
perfect light contrast.

Motion Detection

The camera transmits an alert signal to
the REMOTE jack when it detects motion
of an object. If you connect an optional
alarm to the camera, you can get the
effective surveillance.

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

76

Contents

Front

Side

Bottom

Back

Lens

• Installing Auto Iris Lens

• Installing C/CS-Mount Lens

Connecting to Monitor

Connecting to Power

8 21

21
22
23
26
27
28
32
33
34
35
36
38
40

41

10

11

15
15

19
20

11
12
13
14

Operating Your Camera

Configuration of The Menu
Setting Up The Menu

• Camera ID

• Backlight

• White Balance

• Motion Detection

• Lens Selection

• Shutter Speed Control

• Sense up

• Color(Day / Night)

• Synchronization Mode

• Special
Using Remote Jack / MD Output

Troubleshooting

43

Specifications

Connection

Precautions

Composition

Name and Function of Each Part

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

98

Precautions

Do not install the camera in
extreme temperature conditions.

Only use the camera under conditions
where temperatures are between -10 C
and +50

C. Be especially careful to provide
ventilation when operating under high
temperatures.

Do not install or use the camera in an
environment where the humidity is high.

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

1110

Composition

Front

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

1312

Name and Function of Each Section

Bottom

Tripod Mounting Bracket

Tripod Mounting Hole

Used to install the camera on an optional
tripod. The tripod must be equipped with
the screw specified as shown below.

1/4"-20 UNC (20 THREAD)
L:4.5mm±0.2mm (ISO standard),
or 0.197" (ASA standard)

L

You can remove and install this bracket on the top of
the camera. You must use the supplied screw or the
equivalent (within 4mm). If not, the bracket may not
be fixed properly.

Side

Auto Iris Lens Connector

Used to connect Auto Iris Lens plug.

DC/VIDEO Selection Switch

Used to choose DC or VIDEO
according to the type of your Auto
Iris Lens.

Menu Setup Buttons Cover

Menu Setup Buttons

• SET Button: Used to access menu mode. Also used to confirm the setting.

• UP/DOWN Button: Used to choose the desired menu item. It also moves
the cursor up or down in the menu screen.

• LEFT/RIGHT Button:

Used to change the parameter of the selected menu item.
It also moves the cursor the left or right in the menu screen.

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual

1514

LENS

The lens is not supplied with this camera. Purchase a lens suitable for your
environment. This camera accepts the auto iris lens and both C-and
CS-mount lens.

1. Peel approximately 8mm from the end of the lens cable outer cover.

2. Peel approximately 2mm from the end of the cable inner cover.

If the lens is marked with fingerprints or other marks, the image quality might be poor.
It is recommended to use a high quality lens to improve the image quality under
low illumination.
For using main functions it is recommended to use Auto Iris Lens with DC type.

Notes

Installing Auto Iris Lens

ConnectionName and Function of Each Section

Back

Video Output Jack

Used to connect an external
video monitor in jack.

MD Output Terminal

Used to output motion
detection signal.

AC / DC Power Terminal

Used to connect an AC 24V or DC 12V power source.

Frame Ground

Remote Jack

Used to connect a remote plug.

Power LED

The LED turns on

when power is supplied.

AC/DC Type

High Voltage Type