SAMSUNG SH24ZS6A Service Manual Disassembly & Reassembly

3. Disassembly and Reassembly

Stop operation of the air conditioner and remove the power cord before repairing the unit.

3-1 Indoor Unit

No Parts Procedure Remark

1 Front Panel

1) Stop the air conditioner operation and block
the main power.

2) Detach tape of Front Panel upper.

3) Open the upper Front Grille by pulling right
and left sides of the Grille.

4) Slide the lower Front Grille down, then
disassemble it by pulling it forwards.

5) Take the left and right Filter out.

6) Loosen one of the right screw and detach
the Terminal Cover.

7) Detach the thermistor from the Front Grille.

8) Loosen 5 fixing screws of Front Grille.

9) Pull the lower left and right of discharge
softly for the outside cover to be pulled out.

10) In order to disassemble the Panel Grille,

press, in order, the left, center, and right of
the upper side of the Panel Grille with the
palm of the hand to remove the hook.
And then disassemble the Panel Grille.

9Samsung Electronics

Disassembly and Reassembly

No Parts Procedure Remark

2

3

4

Electrical Parts

(Main PCB)

Tray Drain

Heat Exchanger

1) Take all the connector of PCB upper side
out.(Including Power Cord)

2) Detach the outdoor unit connection wire
from the Terminal Block.

3) If pulling the main PCB up. It will be taken
out.

1) Pull Tray Drain out from the Back Body.

1) Loosen 2 fixing earth screws of right side.

2) Detach the Connection Pipe.

3) Detach the Holder Pipe at the rear side.

4) Loosen 2 fixing screws of right and left
side.

5) Lifting the Heat Exchanger up a little
to push the up side for detach from the
indoor unit.

Samsung Electronics10