SAMSUNG SH07ZZ8X Service Manual Set Up the Model Option
3. Set Up the Model Option
3-1 Setting Option Setup Method
ex) Option No. :
Step 1 : Enter the Option Setup mode.
st
1
nd
2
Take out the batteries of remote control.
Press the temperature button simultaneously and
insert the battery again.
rd
3
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
The default value is .
Otherwise, push the button to .
Every time you push the button, the display panel reads or
repeatedly.
1
2
3
2
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
3
4
5
6
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
4
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
repeatedly.
✳ Setting is not required if you must
a value which has a default.
5
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
6
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
repeatedly.
Samsung Electronics8
7
8
9
10
11
12
7
Press button, then the default value is .
8
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
9
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
10
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
11
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
Set Up the Model Option
repeatedly.
repeatedly.
repeatedly.
✳ Setting is not required if you must
a value which has a default.
12
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Step 4 : Press the ON/OFF button ( )
Step 5 : Unit operation test-run
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is
completed. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
st
If all lamps of indoor unit are flickering, Plug out, plug in again and press ON/OFF key to retry.
1
2ndIf the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for its model.
9Samsung Electronics
Loading...