SAMSUNG SH07ZZ8X Service Manual Disassembly & Reassembly

2. Disassembly and Reassembly

Stop operation of the air conditioner and remove the power cord before repairing the unit.

2-1 Indoor Unit

No Parts Procedure Remark

1 Front Grille

1) Stop the air conditioner operation and
block the main power.

2) Detach tape of Grille Air-Inlet.

3) After Both End Part of the Grille Lower
Position are pressing, it shall be detach by
pushing up.

4) Loosen 1 of the right screw and detach
the Terminal Cover.

5) Detach the thermistor from the Front
Grille.

6) Loosen 3 fixing screws of Front Panel.

3Samsung Electronics

Disassembly and Reassembly

No Parts Procedure Remark

7) Pull the lower left and right of discharge
softly for the outside cover to be pulled out.

8) In order to disassemble the Panel Front
press, in order, the left, center and right of
the upper side of the Panel Grille with the
plam of the hand to remove the hook.
And then disassemble the Panel Grille.

2

3

Tray Drain

Electrical Parts

(Main PCB)

1) Pull Tray Drain out from the Back Body.

1) Take all the connector of PCB upper side
out. (Inclusion Power Cord)

2) Detach the outdoor unit connection wire
from the Terminal Block.

3) If pulling the main PCB up, it will be taken
out.

Samsung Electronics4