This Service Manual isaproperty of Samsung Electronics Co.,Ltd.
Any unauthorized use of Manual can be punished under applicable
International and/or domestic law.
Africamea.samsungportal.com
&
Samsung Electronics Co.,Ltd.
ⓒ
2007. 11.
Rev.1.0
Safety Precautions
1.
Repair Precaution
1-1.
Repair in Shield Box, during detailed tuning.
●
Take specially care of tuning or test,
because specipicty of cellular phone is sensitive for surrounding interference(RF noise).
Be careful to useakind of magnetic object or tool,
●
because performance of parts is damaged by the influence of manetic force.
Surely useastandard screwdriver when you disassemble this product,
●
otherwise screw will be worn away.
Useathicken twisted wire when you measure level.
●
thicken twisted wire has low resistance, therefore error of measurement is few.
A
Repair after separate Test Pack and Set because for short danger(for example an
●
overcurrent and furious flames of parts etc) when you repair board in condition of
connecting Test Pack and tuning on.
Take specially care of soldering, because Land of PCB is small and weak in heat.
●
Surely tune on/off while using AC power plug, becausearepair of battery charger is
●
dangerous when tuning ON/OFF PBA and Connector after disassembing charger.
Don't use as you pleases after change other material than replacement registered on SEC
●
System.
Otherwise engineer in charge isn't charged with problem that you don't keep this rules.
1-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Safety Precautions
ESD(Electrostatically Sensitive D evices) Precaution
1-2.
Several semiconductor may be damaged easilly by static electricity. Such parts are called by
ESD(Electrostatically Sensitive Devices), for example IC,BGA chip etc. Read Precaution below.
You can prevent from ESD damage by static electricity.
Remove static electricity remained your body before you touch semiconductor or parts with
●
semiconductor. There are ways that you touch an earthed place or wear static electricity
prevention string on wrist.
Use earthed soldering steel when you connect or disconnect ESD.
●
Use soldering removing tool to break static electricity.,otherwise ESD will be damaged by
●
static electricity.
Don't unpack until you set up ESD on product. Because most of ESD are packed by box
●
and aluminum plate to have conductive power,they are prevented from static electricity.
You must maintain electric contact between ESD and place due to be set up until ESD is
●
connected completely to the proper place oracircuit board.
1-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Specification
2.
GSM/DCS1800/PCS1900/WCDMA2100 General Specification
2-1.
2-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Specification
GSM TX power class
2-2.
2-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Product Function
3.
Main Function
3G
-
RSS reader
-
Camera and camcorder
-
Synchronisation with Windows Media Player
-
Music player
-
FM radio
-
Image editor
-
Digital data printing
-
Bluetooth
-
File viewer
-
Web browser
-
3-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4.
TestJig(GH80-03307A)
Test Jig(GH
80-03308
A)
Test Cable(GH39-00
RF Test Cable(GH39-00397A)
4-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
890
A)
Array course control
Software Downloading
4-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4-3
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4-4
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4-5
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4-6
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4-7
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
5. Exploded View and Parts List
5-1. Cellular phone Exploded View
QFR01
QCR57
QMW01
QFU01
QLC01
QCA01
QAR01
QMO01
QPC02
QPC01
QSP01
QMP01
QCA10
QKP02
QCR06
QCR84
QCR57
QKP01
QME01
QVK01
QCA02
QMI01
QAN05
QAN02
QSH01
QSH02
QCR05
QCK01
QFL01
QIF01
QSD01
QHI05
QCW01QCH01
QHI01
QCR84QCW02
QCR83
5-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization