Samsung SCW-230E User Manual

Safety Warnings

CD-R/RW DRIVE

SCW-230

http : //www. samsungelectronics. com.

BG68-10024A

User’s Guide - ENGLISH

The following diagrams illustrate the precautions to be taken when using your CD-R/RW drive.

You must not use the drive in any manner other than that specified in this guide.

CAUTION

Do not attempt to repair the CD-R/RW drive yourself. Contact your dealer or local SAMSUNG representative for all repairs.

Use of controls or adjustments or performance of procedures otherthan those specified here in may result in hazardous radiation exposure.

WARRANTY

Please refer to the Samsung limited warranty statements.

To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.

English

SCW-230(E/G/F/S) 3/31/00 2:34 PM Page 1

Front View of the CD-R/RW Drive Rear View of the CD-R/RW Drive

2 3

COMPACT

Recordable

WRITING DISC IN

ReWritable

12 3456

Headphone Connector

The audio output connector enables you to plug stereo headphones into the drive. It requires a 3.6mm stereo mini-jack.

Volume Control Dial

This control dial adjusts the volume for your headphones. You can only use the headphone jack and volume control when you have installed the required software utilities. For example, the Microsoft Windows Media player can be used.

Writing LED

When you write data in the disc.(Blink:Test mode, On:Write mode)

Reading/Disc In LED

When you play a disc or when you place a disc in the tray.

Disc Tray

The Disc Tray opens and closes automatically when you press the Open/Close button.

◆ When you place a disc in the tray, make sure that the label on the disc is facing upwards. If you are not loading or unloading a disc, the disc tray should remain closed.

Open/Close-Button

Press open/close key.

12 3 4

Audio Output Connector

You can connect a sound card to your drive using this four-pin connector. ☛ This function is not covered in detail in this guide. Refer to the documentation

supplied with your sound card.

Device Configuration Jumper

Usually, this is a pre-set configuration as illustrated below:

☛ Verify that the setting is as illustrated. If it is not, simply remove the jumper

and place it in the correct position.

Host IDE Interface Connector

This input/output interface connector is used to connect the 40-pin flat cable from the IDE interface to the CD-R/RW drive.

Power Connector

The power connector is a four-conductor male plug.

CSSLM

English

SCW-230(E/G/F/S) 3/31/00 2:35 PM Page 2

+ 3 hidden pages