Samsung SCH-210B Specifications

2. Specification
£´60 -22 ~ 140 )
Operating Temperature : 20 ~ £´50 ( 4 ~ 122 ) Operating Voltage
HHP : 7.2V DC ( 10 ) Hands-free : 13.7V DC ( 10 )
Size and Weight
including standard battery : 130 51 27.5 mm, 205 g (5.12 2 0.94 inch, 7.2 oz) including extended-life battery : 130 51 37 mm, 207 g (5.12 2 1.46 inch, 7.4 oz)
Operating Time
Digital mode Standby Time : about 50 ~ 55 hours (with standard battery)
: about 85 ~ 90 hours (with extended-life battery)
Talk Time : about 150 min (with standard battery)
: about 250 min (with extended-life battery)
Analog Standby Time : about 10 ~ 12 hours (with standard battery)
: about 16 ~ 18 hours (with extended-life battery)
Talk Time : about 100 min (with standard battery)
: about 170 min (with extended-life battery)
2-2 Analog Mode
TRANSMITTER
RF output power : 0.6 W ( 2/ 4 dB) Carrier ON/OFF Conditions
"ON" Condition : within 3 dB of specification output (in 2mS) "OFF" Condition : below 60 dBm (in 2mS)
Compressor
Compression Rate : 2:1 Attack Time : 3 mS Recovery Time : 13.5 mS Reference Input : Input level for producing a nominal 2.9 kHz peak frequency
deviation of transmitted carrier
2-1 General
Frequency Range Digital Mode Analog Mode
Transmitter : 824.64 ~ 848.37 MHz 824.04 ~ 848.97 MHz
Receiver : 869.64 ~ 893.37 MHz 869.04 ~ 893.97 MHz Channel Spacing : 1.23 MHz 30 kHz Number of Channels : 20 FA 832 CHs Duplex Spacing : 45 MHz
Frequency Stability : 2.5 ppm ( 30 ~
Samsung Electronics - Contents may change without notice. 2-1
Specification
Preamphasis : 6 dB/OCT within 0.3 ~ 3 kHz Maximum Frequency Deviation
F3 of G3 : 12 kHz ( 10 )
Supervisory Audio Tone : 2 kHz ( 10 )
Signaling Tone : 8 kHz ( 10 )
Wideband Data : 8 kHz ( 10 ) Post Deviation Limiter Filter
3.0 kHz ~ 5.9 kHz : above 40LOG (F/3000) dB
5.9 kHz ~ 6.1 kHz : above 35 dB
6.1 kHz ~ 15 kHz : above 40LOG (F/3000) dB
Over 15 kHz : above 28 dB Spectrum Noise Suppression
For All Modulation
f 20 kHz ~ f 45 kHz : above 26 dB
For Modulation by Voice and SAT
f 45 kHz : above 63 10LOG (Py) dB
For Modulation by WBD (without SAT) and ST (with SAT)
f 45 kHz ~ f 60 kHz : above 45 dB f 60 kHz ~ f 90 kHz : above 65 dB f 90 kHz ~ 2f : above 63 10LOG (Py) dB
(where f = carrier frequency
Py= mean output power in watts)
Harmonic and Conducted Spurious Emissions : above 43 10LOG (Py) dB
RECEIVER
DE-Emphasis : 6 dB/OCT within 0.3 ~ 3 kHz Expander
Expansion Rate : 1:2
Attack Time : within 3 mS
Recovery Time : within 13.5 mS
Reference Input : Output level to a 1000 Hz tone from a carrier within 2 . 9
kHz peak frequency deviation Sensitivity : 12 dB SINAD/ 116 dBm Intermodulation Spurious Response Attenuation : above 65 dB RSSI Range : above 60 dB Protection Against Spurious Response Interference : above 60 dB In Band Conducted Spurious Emissions
Transmit Band : below 60 dBm Receive Band : below 80 dBm
Out of Band Conducted Spurious Emissions : below 47 dBm
2-2 Samsung Electronics - Contents may change without notice.
Loading...
+ 4 hidden pages